Polycom 1725-22886-001/A manual Check the Screens and Run the Wizard

Page 17

Check the Screens and Run the Wizard

Check the Screens and Run the Wizard

1

Make sure the Welcome screen image is centered properly on the screen.

If you need to adjust the projected image, follow the instructions in the “Adjusting the Projected Image” section of the Rear Projection SMART Board 3000i Installation Guide.

The adjustments that you make at this point are coarse adjustments; you will be able to make fine adjustments later.

2

Make sure the Welcome screen image is in focus.

If you need to adjust the projector focus, follow the instructions in the “The NEC VT670 Projector” section of the Rear Projection SMART Board 3000i Installation Guide.

3

Complete the VSX setup wizard.

Use the Polycom remote control to complete the wizard. For information about using the remote control, refer to the Polycom Getting Started Guide for VSX Series Systems.

Touch control is not enabled at this stage of the setup; however, you will be able to use touch control for most of the system configuration and customization.

For information about the VSX system, refer to the Polycom Administrator’s Guide for the VSX Series.

11

Image 17
Contents Setting Up the Polycom Instructor RP Trademark Information About this Guide Setting Up the Polycom Instructor RP Contents Setting Up the Polycom Instructor RP Setting Up the Polycom Instructor RP Unpack and Position the System You should find these accessory boxes Prepare to Install the EquipmentRemove the rear access panel from the cabinet Connect the Standard Equipment Connect the Optional Equipment Connect the Optional Equipment Connect a guest laptop to the Polycom Instructor RP system Complete the Equipment Installation Power on the System Check the Screens and Run the Wizard Calibrate the Annotation Box Calibrate the Annotation Box Setting Up the Polycom Instructor RP Rear Projection Smart Board 3000i Installation Guide Install the Software and Complete the CalibrationUser’s Guide Configure and Use the SystemIf the system It often means Correct it this way TroubleshootingIf the system It often means Correct it this way