Polycom 1725-22886-001/A manual Unpack and Position the System

Page 8

Setting Up the Polycom Instructor RP

Unpack and Position the System

1

Work with another person to unpack the Polycom Instructor RP system.

To perform this step, follow the instructions in Unpacking the Rear Projection SMART Board Interactive Whiteboard that is attached to the outside of the crate.

Caution Be sure the wheels are unlocked before you try to move the system.

Be careful when you move the system. Quick stops, excessive force, and movement over uneven surfaces can overturn the system.

2

Work with another person to roll the Polycom Instructor RP off the pallet and move it to the room where you will be using it.

Position the system so that it does not face toward a window or other source of bright light.

Leave space in front of the system so that you can open the doors.

Leave space behind the system so that you can work.

Set up the system in an area with as little dust, humidity, and smoke as possible.

Lock the wheels when the system is in the desired place.

2

Image 8
Contents Setting Up the Polycom Instructor RP Trademark Information About this Guide Setting Up the Polycom Instructor RP Contents Setting Up the Polycom Instructor RP Setting Up the Polycom Instructor RP Unpack and Position the System Prepare to Install the Equipment You should find these accessory boxesRemove the rear access panel from the cabinet Connect the Standard Equipment Connect the Optional Equipment Connect the Optional Equipment Connect a guest laptop to the Polycom Instructor RP system Complete the Equipment Installation Power on the System Check the Screens and Run the Wizard Calibrate the Annotation Box Calibrate the Annotation Box Setting Up the Polycom Instructor RP Install the Software and Complete the Calibration Rear Projection Smart Board 3000i Installation GuideConfigure and Use the System User’s GuideTroubleshooting If the system It often means Correct it this wayIf the system It often means Correct it this way