Polycom DOC2231A manual Administrator’s Guide, Chapter

MGC+50/MGC+100 Getting Started Guide

Table 8-2: MCU's Cards Status Columns

Field	Description
Clock	This column is valid only for ISDN and Serial (MPI-8)
	Network Interface cards.
	On the Net-2/Net-4/Net-8 Network Interface Module,
	the Master and the Backup clocks can be set on any
	of the spans connected to the module.
	This column indicates which Network card/span is
	used as the Master Clock and which one is used as
	the Backup clock.
Configured Clock	Indicates which ISDN Network card or MPI Span
	was configured as the Primary network interface (for
	clocking), and which one is used as backup.
	Changes take effect and are updated during the next
	MCU reset or power up.
Status	Indicates the card status; Normal or Faulty.
Occupied Units	Indicates the units on the card that are currently
	used to run conferences. For example, 1, 6 indicates
	that two units, unit # 1 and unit # 6 are used to run
	conferences.
Faulty Units	Indicates if there are units on the card which are
	faulty and the sequential number of the faulty unit.
Disabled Units	Indicates the units that were disabled by the
	operator.
Num Units	Indicates the total number of units available for each
	module.

For more information about viewing card parameters, see MGC Manager

Administrator’s Guide, Chapter 4.

8-10