TP-Link TD-W8910GB manual FCC RF Radiation Exposure Statement, CE Mark Warning

Page 3

TD-W8910GB54M Wireless ADSL2+ Router User Guide

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

II

Image 3
Contents TD-W8910GB 54M Wireless ADSL2+ Router Copyright & Trademarks CE Mark Warning FCC RF Radiation Exposure Statement2400.0-2483.5 MHz Country Restriction Reason/remark National RestrictionsPackage Contents Contents Appendix a Appendix BTD-W8910GB Overview of the Router Main FeaturesWireless Product OverviewTransmit Data-rate Supporting ProtocolBack Panel Hardware Installation GuideFront Panel LED ExplanationSystem Requirements Installation Environment RequirementsConnect Adsl Line Connecting the RouterBest Location for Wireless Network Connection Wired network connectionComputer to Router Connection Hub or Switch to Router ConnectionConfigure PC Quick Installation GuideTD-W8910GB54M Wireless ADSL2+ Router User Guide TD-W8910GB54M Wireless ADSL2+ Router User Guide If the TCP/IP configuration for your PC is correct? Configure the Router TD-W8910GB54M Wireless ADSL2+ Router User Guide TD-W8910GB54M Wireless ADSL2+ Router User Guide TD-W8910GB54M Wireless ADSL2+ Router User Guide Login Basic Router ConfigurationDevice Info Quick Setup Advanced Setup1 WAN Follow the instructions below to Add or Edit an ATM PVC TD-W8910GB54M Wireless ADSL2+ Router User Guide Configuration will be described in 5.4.5 Quality of Service PPPoA 4to configure them againTD-W8910GB54M Wireless ADSL2+ Router User Guide MER PPPoETD-W8910GB54M Wireless ADSL2+ Router User Guide IPoA Bridge 2 LAN TD-W8910GB54M Wireless ADSL2+ Router User Guide MAC Clone Virtual Servers 4 NATTo setup a virtual server entry TD-W8910GB54M Wireless ADSL2+ Router User Guide To add a new Port Triggering Port TriggeringDMZ Host Security To add a new DMZ HostALG IP Filtering Setup an Outgoing IP Filtering ruleTD-W8910GB54M Wireless ADSL2+ Router User Guide Setup an Incoming IP Filtering rule MAC Filtering To setup a MAC Filtering ruleParental Control To setup a Parental Control ruleQuality of Service TD-W8910GB54M Wireless ADSL2+ Router User Guide Routing To add static routing entries Static RouteRIP To remove a static routing entryDNS Server 8 DNSDynamic DNS To setup DDNS, follow these instructions9 DSL Port Mapping TD-W8910GB54M Wireless ADSL2+ Router User Guide Wireless Basic Wireless LAN ConfigurationWEP Encryption Wireless SecurityConfigure WEP Encryption WPA Configure WPA settings WPA-PSK Configure WPA-PSK settingsWPA2 Mixed WPA2/WPA WPA2-PSKMixed WPA2/WPA-PSK Wireless -- MAC FilterForm of MAC Address must be xxxxxxxxxxxx, like 00130A55FF09 Wireless AdvancedTD-W8910GB54M Wireless ADSL2+ Router User Guide Wireless Statistics DiagnosticsManagement SettingsBackup To back up the Router’s current settingsUpdate System Log To update the Router’s settingsTo View the System Log To Configure the System Log SettingsInternet Time To set the Router’s time 4 TR-069 clientRPC- Remote Procedure Calls Services Access ControlTo add the IP Address PasswordsTo change the password Update SoftwareTo update the Routers software RebootAppendix a Glossary TD-W8910GB54M Wireless ADSL2+ Router User Guide TD-W8910GB54M Wireless ADSL2+ Router User Guide TD-W8910GB54M Wireless ADSL2+ Router User Guide LED LAN/WAN Appendix B Specifications