Prestige 641 ADSL Internet Access Router
Field | Description | Options |
|
|
|
Route | This field determines the protocols that your Prestige will |
|
| route. |
|
|
|
|
Bridge | Bridging is used for protocols that the Prestige doe not | Press |
| support, e.g., SNA, or not turned on in the previous Route | space bar |
| field. When bridging is enabled, your Prestige will forward | to toggle |
| any packet that it does not route to this remote node; | Yes/No |
| otherwise, the packets are discarded. . | |
|
| |
|
|
|
Edit PPP Options | To edit the PPP options for this remote node, move the | Press |
| cursor to this field, use the space bar to select Yes and | space bar |
| press [Enter]. This will bring you to Menu 11.2 - Remote | to toggle |
| Node PPP Options. For more information on configuring | Yes then |
| PPP options, see the section Editing PPP Options. | press |
|
| [Enter] |
|
|
|
Rem IP Addr | Enter the IP address of the remote gateway. |
|
|
|
|
Edit IP/IPX/Bridge | Press the space bar to select Yes and press Enter to go to | Yes or No |
| Menu 11.3 - Remote Node Network Layer Options menu. |
|
|
|
|
Session Option: | Use the space bar to toggle this field to Yes and press | Default= |
Edit Filter Sets | [Enter] to open Menu 11.5 to edit the filter sets. See the | No |
Remote Node Filter section for more details. |
| |
|
| |
|
|
|
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [Enter] at the message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to cancel.
4.1.3 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons. However, some vendor’s implementation includes specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated protocol is stronger than specified. If you encounter the case where the peer disconnects right after a successful authentication, please make sure that you specify the correct authentication protocol when connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP Options, move the cursor to the Edit PPP Options field in Menu 11.1 - Remote Node Profile, and use the space bar to select Yes. Press Enter to open Menu 11.2, as shown next.
Remote Node Configuration |