ZyXEL Communications 641 manual IPX Remote Node Setup

Prestige 641 ADSL Internet Access Router

6.4.1 IPX Remote Node Setup

Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 - Remote Node Profile. For the IPX-specific parameters in Menu 11.3 - Remote Node Network Layer Options follow the instructions below.

Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should display Route = IPX or Route = IP + IPX.)

Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select Yes and press [Enter] to open Menu 11.3 - Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

VPI/VCI (RFC1483 LLC/PPP/ENET ENCAP) :	IPX Options:
VPI #= 1	Rem LAN Net #= 00000000
VCI #= 1	My WAN Net #= 00000000
IP Options:	Hop Count= 1
IP Address Assignment= Static	Tick Count= 2
Rem IP Addr:
Rem Subnet Mask= N/A	Bridge Options:
My WAN Addr= N/A	Ethernet Addr Timeout(min)= N/A
Single User Account= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A

Enter here to CONFIRM or ESC to CANCEL:

Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options (for LLC-based multiplexing)

6-6 IPX Configuration