7.2.3Selecting the PIP Source
To select a PiP source you have to set the
configurations and then select the desired input.
7.2.3.1Selecting the PiP Source via the Front Panel Buttons
Press and hold the PIP front panel button while pressing the input button of the required PiP source.
For example, to select CV 1 as the PiP source over DP as the main source, press the PIP front panel button while pressing the CV 1 front panel button (see Figure
26).
In this example, the DP button is illuminated and the CV 1 button blinks
Figure 26: CV1 superimposed over DP
7.2.3.2Selecting the PiP Source via the IR Remote Control Transmitter
Press the PIP button on the IR transmitter (the PIP front panel button is illuminated). Press the desired PiP source button on the IR transmitter (see Section 8.7).
7.2.3.3Selecting the PiP Source via the REMOTE Terminal Block Connector
See Section 8.6.
44 | |
|
|