Kramer Electronics VS-66hdcp Connecting to the VS-66HDCP via RS-232, Operating via the Ethernet

Operating the VS-66HDCP 6 x 6 DVI Matrix Switcher

7.4.4Acquiring the Default EDID

To reset to the default EDID, do the following:

1.Turn ON the VS-66HDCP.

2.Press the EDID and STO buttons simultaneously and hold them for 3 seconds.

Both buttons flash.

3.Press the SELECT IN button to which the EDID will be copied. The selected input number flashes on the display.

4.Press the OFF button until a "0" (zero) appears on the display.

5.Press the EDID button.

The process is complete when the display returns to normal.

7.5Connecting to the VS-66HDCP via RS-232

You can connect to the VS-66HDCPvia an RS-232 connection using, for example, a PC. Note that a null-modem adapter/connection is not required. To connect to the VS-66HDCPvia RS-232:

•Connect the RS-232 9-pin D-sub rear panel port on the VS-66HDCPunit via a 9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need to be connected) to the RS-232 9-pin D-sub port on your PC

7.6Operating via the ETHERNET

You can connect the VS-66HDCPvia the Ethernet, using a crossover cable (see section 7.6.1) for direct connection to the PC or a straight-through cable (see section 7.6.2) for connection via a network hub or network router1.

7.6.1Connecting the ETHERNET Port directly to a PC (Crossover Cable)

You can connect the Ethernet port of the VS-66HDCPto the Ethernet port on your PC, via a crossover cable with RJ-45 connectors.

This type of connection is recommended for identifying the VS-66HDCP

with the factory configured default IP address

1 After connecting the Ethernet port, you have to install and configure your Ethernet Port. For detailed instructions, see the “Ethernet Configuration (FC-11) guide.pdf” file in the technical support section on our Web site: http://www.kramerelectronics.com

14 KRAMER: SIMPLE CREATIVE TECHNOLOGY