Peavey XR 696 manual Rec Out, Channel

	NOTE: Channels 5-9 contain features that differ from the previous	6	low		7 STEREO
	channels. Only those features are mentioned below. For information on		cut
	features not mentioned please refer to the section for Channels 1-4.		5		5		11
CHANNELS 5-6		0	10	EFX.	0	10	EFX.
10.	LINE: 1/4" balanced TRS input for line-level signals. This signal is		0		0
	connected through a 25 dB pad to the mic input below it.
11.	LOW CUT: This is a low-cut filter with a corner frequency of 80 Hz used	-15	+15	HIGH	-15	+15	HIGH
			0		0
	to filter rumble, wind noise, breath thumps, stage noise, and other low-
	frequency components that rob power from the amplifiers and muddy the	-15	+15	MID	-15	+15	MID
	signal. Depressing this switch will affect Channels 1 - 6 only. Use of the
			0		0
	filter will not affect the monitor signal.
CHANNELS 7-8		-15	+15	LOW	-15	+15	LOW
			5		5
12.	RIGHT INPUT: High-impedance 1/4" input for line-level signals. The Right
	Input is adjusted by the Level control (#4). If the XR® 696 is in Left/Right	0	10	MON	0	10	MON
	mode then the signal will go to the Right Speaker Output (#37). In
		0dB			0dB
	Mon/Main mode the signal is combined with the Left and placed on the
		-3	+3		-3	+3
	Main Speaker Output. The right signal can also be patched out of the XR	-6	+6		-6		+6
	696 via the Right Output jack (#31) to external components such as		+20 GAIN			+20 GAIN
	effects, power amps, and recording devices.	PAD		6			7
13.	LEFT/MONO INPUT: High-impedance 1/4" input for line-level signals. The		-25dB				13
							LEFT/
	Left/Mono input supplies signal to both the Left and Right channels (if
					LINE	MONO
	there is nothing inserted to the right input jack) through the Level control						12
	(#4). In Left/Right mode the signal will go to the Left Speaker Output (and
	Right Speaker Output if nothing is inserted to the right input jack). In			LINE			RIGHT
	Mon/Main mode the signal is combined with the Right and placed on the						10
	Main Speaker Output.
			MIC			MIC

CHANNEL 9

14.TAPE IN: This stereo RCA phono jack accepts a stereo input (nominally -10 dBV) from the output of a tape deck or CD player and places it on the Left and Right channels as well as the monitor mix.

15.TAPE OUT: This stereo RCA phono jack provides a signal for the recording inputs of a stereo tape deck.

CAUTION: DO NOT HOOK THE TAPE IN AND TAPE OUT TO THE INPUT AND OUTPUT OF THE SAME DECK. DOING SO WILL FORM A LOOP CAUSING SEVERE FEEDBACK. USE SEPARATE DECKS FOR RECORDING AND PLAYBACK.

LINE IN

LEFT RIGHT

14

LEFT RIGHT 15

REC OUT

5