28.EFX DEFEAT: This 1/4" jack accepts an on/off 1/4" footswitch (Peavey Pt. #00051000) to defeat the effects of both the Main and Monitor mixes.
29.MONITOR OUTPUT: This 1/4" jack provides an output from the monitor mix to supply external power amp/monitor combinations. The level of this signal is determined by the Monitor Level control.
30.LEFT/MONO OUTPUT: This 1/4" jack provides an output from the Left Main mix to supply external amp/speaker combinations. The level of this signal is determined by the Main Level control. When no plug is connected to the Right Output (#31) then the right signal is mixed with the left, and both can be accessed at the Left/Mono Output. This works well when you use the internal amps for monitor and external amps for Main. Only one patch cord is required to get the Main out to the external amp. In order to utilize both internal amps for Monitors then patch from Monitor Out into Right Power input.
31.RIGHT OUTPUT: This 1/4" jack provides an output from the Right Main mix to supply external amp/speaker combinations. The level of this signal is determined by the Main Level control.
32.POWER AMP INPUTS: Plugging into these jacks allows the user to go directly into the graphic equalizer, then into its respective power amplifier channel, and therefore bypass the other functions of the XR® 696.
33.POWER LED: The power “on” LED indicator will light when the unit is powered.
AC POWER AND POWER AMPLIFIER SECTION:
34.A/C POWER INLET: This is the receptacle for an IEC line cord, which provides AC power to the mixer/amplifier. Connect the line 
cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used (see line voltage marking on unit).
35.POWER: The XR 696’s main power switch. The power on LED indicator (#33) will light when the unit is powered.
34 | 36 |
| 35 | |
|
| POWER | ||
120 VAC | FUSE | OFF | ON | |
60 Hz | ||||
15 AMP | ||||
500 WATTS |
|
| ||
|
|
| ||
36.FUSE: This is the main safety fuse for the AC line voltage. Only
replace the fuse with one the exact same type and rating. IF THE FUSE CONTINUES TO OPEN, DO NOT OVER FUSE. TAKE THE UNIT TO AN AUTHORIZED PEAVEY SERVICE CENTER!
37.PARALLEL LEFT/RIGHT SPEAKER OUTPUTS: These 1/4" jacks are the amplifier’s outputs. By connecting a speaker cable to this jack and to a speaker cabinet, you complete the signal chain.
You will notice that there are two pairs of jacks. The two pairs are your two (stereo) amp outputs. Two cabinets can be connected to each channel, as long as the combined impedance of the cabinets is not less than 4 Ohms. (i.e., two 8 Ohm cabinets in parallel = 4 Ohms, four 16 Ohm speakers in parallel = 4 Ohms, etc.).
RIGHT/MAIN |
|
| LEFT/ MONITOR | ||
4 OHM MIN | CLASS 2 WIRING | 4 OHM MIN | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
37
8