Canon LV-X2 owner manual Auto PC Adjustment, PC Adjust Menu

Page 24

COMPUTER INPUT

PC ADJUSTMENT

AUTO PC ADJUSTMENT

The Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to your computer. Auto PC Adjustment function can be operated as follows.

	Auto PC Adj.
1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press POINT LEFT/RIGHT button to move the red
	frame to PC ADJUST Menu icon.
2	Press the POINT DOWN button to move the red frame to the
	AUTO PC Adj. icon and then press the SET button twice.

This Auto PC Adjustment can be also executed by pressing the AUTO PC ADJ. button on the Remote Control Unit.

Store adjustment parameters.

Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, setting can be done just by selecting Mode in PC SYSTEM Menu (P22). Refer to step 3 of MANUAL PC ADJUSTMENT section (P26).

NOTE

●Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustment function. When the image is not provided properly through this function, manual adjustments are required. (Refer to page 25, 26.)

●Auto PC Adjustment function cannot be operated when “RGB,” “720p (HDTV),” “1035i (HDTV)” or “1080i (HDTV)” is selected on PC SYSTEM Menu (P22).

PC ADJUST MENU

PC ADJUST Menu icon

Move the red frame to AUTO PC Adj. icon and press SET button.

24

Image 24

Contents LV-X2 To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission NoticeTable of Contents Features and Design Wide Zoom LensPreparation NomenchtorHOT AIR Exhausted SETTING-UP the Projector Connecting AC Power CordFor Continental Europe Adjustable Feet Preparation Positioning the ProjectorRoom Light Preparation Mounting the Lens Cover Moving the ProjectorConnecting the Projector Terminals of the ProjectorVideo AV AudioConnecting to a Computer Terminals ProjectorConnecting Video Equipment Audio OUTOperation of the Remote Control Unit Before OperationRemote Control Unit Battery Installation BatteryBefore Operation Operating Range TOP Controls and Indicators Ready IndicatorHOW to Operate the ON-SCREEN Menu Operating the ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Before Operation Menu BAR Guide WindowBasic Operation Turning on / OFF the ProjectorTurning on the Projector Turning OFF the ProjectorAdjusting the Screen Zoom AdjustmentFocus Adjustment Keystone AdjustmentSound Adjustment Timer FunctionBasic Operation No Show Function Direct OperationComputer Input Selecting the Input SourceSelecting the Computer System AutoComputer Input Compatible Computer Specifications ResolutionFreq KHzPC Adjustment Auto PC AdjustmentPC Adjust Menu Auto PC AdjComputer Input Manual PC Adjustment Display area Display area HFull screen Picture Image Adjustment Image Level Select DirectImage Level Select Menu Image Select MenuComputer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input VideoSelecting the Video System AutoAV System Menu Video or S-VIDEO AV System Menu Component VideoCinema Video Input Image Level Adjustment Reset all adjustment to the previous figure Setting Setting MenuSetting Menu To change the code of the Remote Control Unit Power managementRemote control Lamp counter resetLamp Replacement AppendixLamp Replace Lamp Handling Precautions Appendix Lamp Replace CounterMaintenance AIR Filter Care and CleaningCleaning Projection Lens RecommendationTroubleshooting Remote Control Unit Does not workTechnical Specifications Optional PartsAppendix Configurations of the Terminals Control Port ConnectorUSB Connector Series B Computer Input Terminal AnalogCanon U.S.A., INC