SETTING
Power management
This function turns the Projection Lamp off when this projector detects signal interruption and is not used for a certain period in order to reduce power consumption and maintain the
Power Management function operates to turn the Projection Lamp off when the input signal is interrupted and any button is not pressed over 5 minutes. This function operates as follows;
1.When any input signal is interrupted, “No signal” and the count down display appears (for 5 minutes).
2.After counting down for 5 minutes, the Projection Lamp and the READY Indicator are turned off. (Cooling Fans keep running.)
3.The READY Indicator starts to flash after cooling down the Projection Lamp about for 90 seconds (Power Management mode).
In this Power Management mode, the Projection Lamp is automatically turned on when the input signal is connected or the projector is operated with any button on the Top Control or on the Remote Control Unit again.
Remote control
This projector has two different remote control codes; the
When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”
To change the code of Projector;
Set the Remote control in the SETTING MENU to “Code 2.”
To change the code of the Remote Control Unit;
Press both the MENU and the IMAGE buttons on the Remote Control Unit together for over 10 seconds.
After changing the code, make sure the Remote Control Unit operates properly.
To return to the normal code (Code 1), repeat the steps above.
NOTE : When the battery of Remote Control Unit is replaced, the remote control code automatically returns to the normal code (Code 1).
Lamp counter reset
This function is used to reset the Lamp Replace Counter. When replacing the Projection Lamp, reset the Lamp Replace Counter by using this function. Refer to page 38 for operation.
Time left until Lamp off.
36