Canon LV-X2 owner manual Video Input

Page 30

VIDEO INPUT

SELECTING THE INPUT SOURCE

DIRECT OPERATION

Choose Video by pressing the INPUT button on the Top Control or on the Remote Control Unit.

If the projector cannot reproduce a proper video source, select correct input source through the MENU OPERATION (see below).

INPUT button

Video

Computer

		MENU OPERATION
1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press the POINT LEFT/RIGHT button to move the red
	frame to the INPUT Menu icon.
2	Press the POINT DOWN button to move the red arrow to Video
	and then press the SET button. The Source Select Menu will
	appear.
3	Move the red arrow to the source that you want to select and
	then press the SET button.
		The projector automatically detects incoming the Video
	Auto
		signal, and adjusts itself to optimize its performance.

•When both VIDEO jack and S-VIDEO jack are connected, S-VIDEO jack has priority over VIDEO jack.

•When both Y-Pb/Cb-Pr/Cr jacks and S-VIDEO jack are connected, Y-Pb/Cb-Pr/Cr jacks have priority over S- VIDEO jack.

Video	When the video input signal is connected to VIDEO jack,
	select Video.
	select Video.
	When the video input signal is connected to S-VIDEO
S-Video	When the video input signal is connected to S-VIDEO
	jack, select S-Video.
	jack, select S-Video.

Y,Pb/Cb,Pr/Cr When the video input signal is connected to Y-Pb/Cb- Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.

INPUT MENU

Move the red arrow to Video and press the SET button.

VIDEO

Source Select Menu (VIDEO)

Move the red arrow to the source and press the SET button.

30

Image 30

Contents LV-X2 To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission NoticeTable of Contents Features and Design Wide Zoom LensPreparation NomenchtorHOT AIR Exhausted SETTING-UP the Projector Connecting AC Power CordFor Continental Europe Adjustable Feet Preparation Positioning the ProjectorRoom Light Preparation Mounting the Lens Cover Moving the ProjectorVideo Connecting the ProjectorTerminals of the Projector AV AudioConnecting to a Computer Terminals ProjectorConnecting Video Equipment Audio OUTOperation of the Remote Control Unit Before OperationRemote Control Unit Battery Installation BatteryBefore Operation Operating Range TOP Controls and Indicators Ready IndicatorHOW to Operate the ON-SCREEN Menu Operating the ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Before Operation Menu BAR Guide WindowTurning on the Projector Basic OperationTurning on / OFF the Projector Turning OFF the ProjectorFocus Adjustment Adjusting the ScreenZoom Adjustment Keystone AdjustmentBasic Operation No Show Function Sound AdjustmentTimer Function Direct OperationSelecting the Computer System Computer InputSelecting the Input Source AutoFreq Computer Input Compatible Computer SpecificationsResolution KHzPC Adjust Menu PC AdjustmentAuto PC Adjustment Auto PC AdjComputer Input Manual PC Adjustment Display area Display area HFull screen Image Level Select Menu Picture Image AdjustmentImage Level Select Direct Image Select MenuComputer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input VideoAV System Menu Video or S-VIDEO Selecting the Video SystemAuto AV System Menu Component VideoCinema Video Input Image Level Adjustment Reset all adjustment to the previous figure Setting Setting MenuSetting Menu Remote control To change the code of the Remote Control UnitPower management Lamp counter resetLamp Replacement AppendixLamp Replace Lamp Handling Precautions Appendix Lamp Replace CounterCleaning Projection Lens MaintenanceAIR Filter Care and Cleaning RecommendationTroubleshooting Remote Control Unit Does not workTechnical Specifications Optional PartsUSB Connector Series B Appendix Configurations of the TerminalsControl Port Connector Computer Input Terminal AnalogCanon U.S.A., INC