Canon LV-X2 owner manual Remote Control Unit, Does not work

Page 41

APPENDIX

Problem:

Try these Solutions

Remote Control Unit

Check the battery.

does not work.

Make sure nothing is between the Infrared Remote Receiver and the Remote Control

Unit.

 

 

Observe maximum operating distance 16.4’ (5m) between the receiver on the projector

 

and the Remote Control Unit.

 

Make sure the code of the Remote Control Unit is set to conform to the projector.

 

(See “SETTING” section on page 35, 36.)

 

 

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the projector or the service center. Give the model number and explain the problem in detail. We will advise you of how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community. (EC)

41

Image 41
Contents LV-X2 To the Owner Voor de klanten in Nederland Safety InstructionsFederal Communication Commission Notice CompliancesTable of Contents Wide Zoom Lens Features and DesignHOT AIR Exhausted PreparationNomenchtor For Continental Europe SETTING-UP the ProjectorConnecting AC Power Cord Room Light Adjustable FeetPreparation Positioning the Projector Moving the Projector Preparation Mounting the Lens CoverTerminals of the Projector Connecting the ProjectorVideo AV AudioTerminals Projector Connecting to a ComputerAudio OUT Connecting Video EquipmentBefore Operation Operation of the Remote Control UnitBefore Operation Operating Range Remote Control Unit Battery InstallationBattery Ready Indicator TOP Controls and IndicatorsFlow of ON-SCREEN Menu Operation HOW to Operate the ON-SCREEN MenuOperating the ON-SCREEN Menu Guide Window Before Operation Menu BARTurning on / OFF the Projector Basic OperationTurning on the Projector Turning OFF the ProjectorZoom Adjustment Adjusting the ScreenFocus Adjustment Keystone AdjustmentTimer Function Sound AdjustmentBasic Operation No Show Function Direct OperationSelecting the Input Source Computer InputSelecting the Computer System AutoResolution Computer Input Compatible Computer SpecificationsFreq KHzAuto PC Adjustment PC AdjustmentPC Adjust Menu Auto PC AdjComputer Input Manual PC Adjustment Full screen Display areaDisplay area H Image Level Select Direct Picture Image AdjustmentImage Level Select Menu Image Select MenuImage Adjust Menu Computer Input Image Level AdjustmentScreen Menu Picture Screen AdjustmentVideo Video InputAuto Selecting the Video SystemAV System Menu Video or S-VIDEO AV System Menu Component VideoCinema Video Input Image Level Adjustment Reset all adjustment to the previous figure Setting Menu SettingSetting Menu Power management To change the code of the Remote Control UnitRemote control Lamp counter resetLamp Replace Lamp ReplacementAppendix Appendix Lamp Replace Counter Lamp Handling PrecautionsAIR Filter Care and Cleaning MaintenanceCleaning Projection Lens RecommendationTroubleshooting Does not work Remote Control UnitOptional Parts Technical SpecificationsControl Port Connector Appendix Configurations of the TerminalsUSB Connector Series B Computer Input Terminal AnalogCanon U.S.A., INC