Compaq Memory Channel Hub manual Internal Components, Rear Components

Page 10

Introduction

1.2.3 Internal Components

The internal components of the Memory Channel hub chassis consist of the following:

One motherboard

Four to eight CCMLA hub linecards

Cooling fan

1.2.4Rear Components

Figure 1-3 shows the components located on the rear of the Memory Channel hub chassis.

Figure 1-3 Rear Components

1

2

 

 

 

3

 

 

 

 

 

 

 

 

 

 

c

7

6

5

4

3

2

1

0

 

 

 

 

 

 

 

 

LJ-06499.AI7

öPower supply

õ-48 Vdc power receptacle CCMLA linecard slots

1–4DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide

Image 10
Contents Installation/Service Guide December Table of Contents Removal and Replacement TablesIntended Audience How to Use This GuideOverview OrganizationConventions Related DocumentsReader’s Comments Components and Controls Front ComponentsIntroduction Operator Control Panel Operator Control PanelInternal Components Rear ComponentsSpecifications Environmental RequirementsPage General Site PreparationInstallation Unpacking the ShipmentMounting Hardware and Component List Installing the 2T-CCMHA-CB Central Office Memory Channel Hub Determining the Installation AreaInstallation Area Attaching the Right Slide Assembly to the Cabinet Rails Attaching the Slide Assemblies to the Cabinet RailsAttaching the Slide Assemblies to the Cabinet Rails Installation Attaching the Inner Races to the Tray Attaching the Inner Slide RacesAchtung LJ-06502A.AI7 Mounting the Chassis and Tray Assembly on the Slides Mounting the Chassis and Tray Assembly on the Slides Installing the Interlock System Achtung Interlock System Removal and Replacement IntroductionRemoval and Replacement Top Cover Removing and Replacing the Top CoverPower Supply Removing the Power SupplyLJ-06514.AI7