Compaq Memory Channel Hub manual Removing and Replacing the Top Cover

Removal and Replacement

3.2 Top Cover

_________________________ Caution ___________________________

Use care when removing and replacing the cover to prevent damage to the RFI gaskets that are located around the cover and opening.

____________________________________________________________

Perform the following procedure to remove the top cover:

1.Unlock the top cover by turning the key, located on the rear of the chassis, clockwise to the unlock position (see Figure 3-1). The lock is unlocked when the key is in the vertical position.

2.Insert two fingers into the finger grip on the rear edge of the top cover.

3.Slide the top cover toward the rear of the chassis and remove (see Figure 3-1).

To replace the top cover, refer to Figure 3-1and reverse steps 1 through 3 of the removal procedure.

Figure 3-1 Removing and Replacing the Top Cover

DIGITAL	Memory
	CentralChannel	Hub
	Office		100/8

LJ-06508.AI7

DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide 3–3