Compaq Memory Channel Hub manual Components and Controls, Front Components

Page 7

1 Introduction

1.1 Overview

The 2T-CCMHA-CB central office Memory Channel hub is used to share and route data between two AlphaServer 4100 central office systems.

1.2 Components and Controls

System components and controls are located at the front, internally, and at the rear of the Memory Channel hub chassis.

1.2.1 Front Components

Figure 1-1 shows the components located on the front of the Memory Channel hub chassis.

DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide 1–1

Image 7
Contents Installation/Service Guide December Table of Contents Tables Removal and ReplacementOrganization How to Use This GuideOverview Intended AudienceConventions Related DocumentsReader’s Comments Front Components Components and ControlsIntroduction Operator Control Panel Operator Control PanelRear Components Internal ComponentsEnvironmental Requirements SpecificationsPage Site Preparation GeneralUnpacking the Shipment InstallationMounting Hardware and Component List Determining the Installation Area Installing the 2T-CCMHA-CB Central Office Memory Channel HubInstallation Area Attaching the Slide Assemblies to the Cabinet Rails Attaching the Right Slide Assembly to the Cabinet RailsAttaching the Slide Assemblies to the Cabinet Rails Installation Attaching the Inner Slide Races Attaching the Inner Races to the TrayAchtung LJ-06502A.AI7 Mounting the Chassis and Tray Assembly on the Slides Mounting the Chassis and Tray Assembly on the Slides Installing the Interlock System Achtung Interlock System Introduction Removal and ReplacementRemoval and Replacement Removing and Replacing the Top Cover Top CoverRemoving the Power Supply Power SupplyLJ-06514.AI7