Compaq Memory Channel Hub manual Specifications, Environmental Requirements

Page 11

Introduction

1.3 Specifications

Table 1-1 contains the physical, environmental, and electrical specifications for the 2T- CCMHA-CB central office Memory Channel hub.

Table 1-1 2T-CCMHA-CB Central Office Memory Channel Hub Specifications

Physical Characteristics

Chassis

 

Weight

13.6 kg (30 lb.)

Length

40.64 cm (16 in.)

Width

48.26 cm (19.0 in.)

Height

17.78 cm (7.00 in.)

 

 

Environmental Requirements

 

 

 

Temperature range

 

Operating

0°C to 40°C (32°F to 104°F)

Non-Operating

-20°C to 95°C (-4°F to 203°F)

Temperature change rate

11°C/hr (20°F/hr) maximum

Wet bulb temperature

28°C (82°F)

(maximum)

 

Dew point temperature

2°C (36°F)

(minimum)

 

Relative humidity

10% to 95% (noncondensing)

Altitude

60 m to 3050 m (-200 ft to 10,000 ft)

 

 

Electrical Requirements

 

 

 

Nominal voltage

-48 Vdc

Operational voltage range

-36 to -72 Vdc

Input current (maximum)

1.25 A at -48 Vdc

Input power

60 W

 

 

DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide 1–5

Image 11
Contents Installation/Service Guide December Table of Contents Tables Removal and ReplacementOrganization How to Use This GuideOverview Intended AudienceReader’s Comments Related DocumentsConventions Front Components Components and ControlsIntroduction Operator Control Panel Operator Control PanelRear Components Internal ComponentsEnvironmental Requirements SpecificationsPage Site Preparation GeneralUnpacking the Shipment InstallationMounting Hardware and Component List Determining the Installation Area Installing the 2T-CCMHA-CB Central Office Memory Channel HubInstallation Area Attaching the Slide Assemblies to the Cabinet Rails Attaching the Right Slide Assembly to the Cabinet RailsAttaching the Slide Assemblies to the Cabinet Rails Installation Attaching the Inner Slide Races Attaching the Inner Races to the TrayAchtung LJ-06502A.AI7 Mounting the Chassis and Tray Assembly on the Slides Mounting the Chassis and Tray Assembly on the Slides Installing the Interlock System Achtung Interlock System Introduction Removal and ReplacementRemoval and Replacement Removing and Replacing the Top Cover Top CoverRemoving the Power Supply Power SupplyLJ-06514.AI7