COMPAQ R6000 UPS Trouble Indicators
Table
Trouble Indicators
Symptom | Possible Cause | Suggested Action |
|
|
|
UPS will not start | No utility power | Contact a licensed electrician to check |
|
| power at the utility power output. |
|
|
|
| Circuit breaker in service panel is | Verify that service panel breaker is in the |
| open. | ON position. |
|
|
|
| Input service wire not connected. | Contact a licensed electrician to install |
|
| the UPS wiring. |
|
|
|
| REPO contacts are closed. | Open the REPO switch. |
Cannot Silence Audible | Switch may be pressed and not |
Alarm | released. |
Release switch.
Verify load, reduce load, and repeat self- test.
UPS switches frequently between battery and AC input
Input voltage in your area differs from the UPS nominal input voltage range setting
Use the Front Panel controls and LCD display to change the COMPAQ R6000 UPS nominal input voltage to match local range (see Chapter 4, “Configuration”).