BOXLIGHT MP-86i Basic operations, To project, Turn on the main power switch of the projector I on

Page 13

Basic operations

To project

1

2

5 7 4 2

5

3

VIDEO RGB

LASER

STANDBY/ON POSITION

RESET

MENU

FREEZE

MAGNIFY VOLUME

OFF

P in P

MUTE

BLANK AUTO TIMER

FOCUSZOOM

7

4

1	Turn on the main power switch of the projector [ I: ON].
1	• The Power indicator lights orange.

2	Press the STANDBY / ON button.
2	• The Power indicator will blink green and then light green.

• The green blinking indicates warmup.

3	Remove the lens cap.
4	Use the ZOOM button to adjust the screen size.

5	Use the FOCUS button to adjust the focus.
5	Use the FOCUS button to adjust the focus.
	(1) The display shown to the right will appear when the FOCUS button is pressed.		+++FOCUS+++
	(2) Use the FOCUS button to adjust the focus until the image is sharp.
	(3) The message “Focus” will disappear if any other button is pressed.

	• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)

6	Turn on the power to the connected equipment.
	Refer to page 31 concerning the connection of other equipment.

7 Press either the INPUT button of the projector or the VIDEO/RGB button of the remote control to select the signal to be projected on the screen.

Example on-screen display

RGB 1

The selected signal input channel will be displayed in the lower right part of the screen.

13

Image 13

Contents Contents FeaturesOutline For the Customers in U.K Power cord Video signal cablesBefore Use Video inputsDo not install on an unstable surface If a problem should occurDo not look through the lens when the lamp is on Use only the indicated power supplyDo not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Battery usage Care and maintenanceClean the projector interior once every two years Avoid installation in humid or dusty locationsAvoid excessively hot locations Sound volumeLens care Cabinet careNames and functions of each part Checking the package ContentsNames and functions of each part Names and functions of each part Remote control transmitter3Close the battery cover 1Remove the battery cover2Loading the batteries Typical LCD Projector and Screen Installation InstallationUsing the adjusters Top view Side viewTurn on the power to the connected equipment Turn on the main power switch of the projector I onBasic operations To projectTurn off the main power switch of the projector OFF Turning off the powerPlug & Play Press the STANDBY/ON button for approximately 1 secondFreeze function Cancelling the Freeze functionPress the Freeze button Changing the magnification ratio Magnify functionMoving the display area Returning to normal displayReturning to the initial settings Adjustments and functionsPress the Menu Using the Setup Menu SET UPInput Image OPT Connection to the RGB signal terminal Connection to the video signal terminalsInput signals Signal input jacksExample of computer signal Connection to the RGB signal terminalInitial set signals Connection to the RGB signal terminalConnecting the USB Mouse functions Connection to the control signal terminalControl signal jack Connection to the control signal terminalRS232C communication System Video Command data chartRequesting projector status Cleaning the Air filter Example of system setupPull out the power cord Remove the front air filterInstall the air filter Clean the air filter with a vacuum cleanerLamp Message tableIndicators TroubleshootingDimensional Diagram Limited Warranty About the warranty and after-serviceQR41981