BOXLIGHT MP-86i Example of system setup, Cleaning the Air filter, Pull out the power cord

Page 31

Example of system setup

Computer

(notebook type)

Computer (desktop type)

AC input

	1	RGB IN	2
	CONTROL		RGB OUT
AUDIO IN		AUDIO
1	2	OUT
			USB

S-VIDEO IN

VIDEO IN

AUDIO IN

MONO

Video tape recorder with S jack

Video tape recorder

Speaker (with built-in amp)

Display monitor

Caution Turn power off to all devices before connecting.

Refer to the instruction manual of each device before connecting.

Cleaning the Air filter

Clean the air filter about every 100 hours .

1		Turn off the MAIN POWER switch of the projector and
		pull out the power cord.

	2	Remove the front air filter.

Image 31

Contents Contents FeaturesOutline For the Customers in U.K Video inputs Video signal cablesPower cord Before UseUse only the indicated power supply If a problem should occurDo not install on an unstable surface Do not look through the lens when the lamp is onDo not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Avoid installation in humid or dusty locations Care and maintenanceBattery usage Clean the projector interior once every two yearsCabinet care Sound volumeAvoid excessively hot locations Lens careNames and functions of each part Checking the package ContentsNames and functions of each part Names and functions of each part Remote control transmitter3Close the battery cover 1Remove the battery cover2Loading the batteries Top view Side view InstallationTypical LCD Projector and Screen Installation Using the adjustersTo project Turn on the main power switch of the projector I onTurn on the power to the connected equipment Basic operationsPress the STANDBY/ON button for approximately 1 second Turning off the powerTurn off the main power switch of the projector OFF Plug & PlayFreeze function Cancelling the Freeze functionPress the Freeze button Returning to normal display Magnify functionChanging the magnification ratio Moving the display areaReturning to the initial settings Adjustments and functionsPress the Menu Using the Setup Menu SET UPInput Image OPT Signal input jacks Connection to the video signal terminalsConnection to the RGB signal terminal Input signalsExample of computer signal Connection to the RGB signal terminalInitial set signals Connection to the RGB signal terminalConnecting the USB Mouse functions Connection to the control signal terminalControl signal jack Connection to the control signal terminal RS232C communication System Video Command data chartRequesting projector status Remove the front air filter Example of system setupCleaning the Air filter Pull out the power cordMessage table Clean the air filter with a vacuum cleanerInstall the air filter LampIndicators TroubleshootingDimensional Diagram Limited Warranty About the warranty and after-serviceQR41981

Example of system setup

Cleaning the Air filter

pull out the power cord.

Remove the front air filter.