BOXLIGHT MP-86i Magnify function, Changing the magnification ratio, Moving the display area

Page 16

Basic operations (continued)

Magnify function	VIDEO	RGB
	LASER
	STANDBY/ON	POSITION

Part of the displayed image can be magnified. (refer to page 10)

5

		RESET
1,2	MENU
1,2		FREEZE
3	MAGNIFY	VOLUME
3		OFF
	P in P	MUTE
	BLANK	AUTO TIMER

1 Press the MAGNIFY + button.

• The center part of the image will be displayed magnified approximately 2x.

Changing the magnification ratio

2 Press the MAGNIFY + button.

• When this button is pressed, the image will be displayed even larger.

4

6

3 Press the MAGNIFY – button.

• When this button is pressed, the image will be displayed even smaller.

Moving the display area

4	Press the POSITION button.
5	Press the DISK PAD up, down, left and right buttons.
	• The magnified area will move in accordance with the button pressed.

Returning to normal display

6 Press the MAGNIFY OFF button.

Caution • When there is no video signal input, Magnify is not effective when the video signal input is outside the sync range.

•The magnify function will be cancelled when the input select button is pressed or the display mode of the PC being used for display is changed.

•The Magnify function will be cancelled after the operations such as “AUTO”, “KEYSTONE”.

16

Image 16

Contents Contents FeaturesOutline For the Customers in U.K Video signal cables Power cordBefore Use Video inputsIf a problem should occur Do not install on an unstable surfaceDo not look through the lens when the lamp is on Use only the indicated power supplyDo not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Care and maintenance Battery usageClean the projector interior once every two years Avoid installation in humid or dusty locationsSound volume Avoid excessively hot locationsLens care Cabinet careChecking the package Contents Names and functions of each partNames and functions of each part Remote control transmitter Names and functions of each part3Close the battery cover 1Remove the battery cover2Loading the batteries Installation Typical LCD Projector and Screen InstallationUsing the adjusters Top view Side view Turn on the main power switch of the projector I on Turn on the power to the connected equipment Basic operations To projectTurning off the power Turn off the main power switch of the projector OFFPlug & Play Press the STANDBY/ON button for approximately 1 secondFreeze function Cancelling the Freeze functionPress the Freeze button Magnify function Changing the magnification ratioMoving the display area Returning to normal displayReturning to the initial settings Adjustments and functionsPress the Menu SET UP Using the Setup MenuInput Image OPT Connection to the video signal terminals Connection to the RGB signal terminalInput signals Signal input jacksConnection to the RGB signal terminal Example of computer signalConnection to the RGB signal terminal Initial set signalsConnecting the USB Connection to the control signal terminal Mouse functionsConnection to the control signal terminal Control signal jackRS232C communication Command data chart System VideoRequesting projector status Example of system setup Cleaning the Air filterPull out the power cord Remove the front air filterClean the air filter with a vacuum cleaner Install the air filterLamp Message tableTroubleshooting IndicatorsDimensional Diagram About the warranty and after-service Limited WarrantyQR41981