BOXLIGHT MP-86i user manual Connecting the USB

Page 25

Connecting the USB

1.Connect the projector and computer with a suitable commercially available cable. Disconnect the mouse cable from the projector.

2.Press the INPUT button of the projector or the RGB 1/2 button of the remote control and select the input where the computer is connected.

3.Start the mouse function.

4.Refer to page 10 concerning the remote control of mouse operations.

5.Varying the force with which the DISK PAD button is pressed varies the speed of mouse operation.

USB jack		Projector			Computer						USB jack
(B type)													(A type)
2	1	+5V	1			1	+5V
2	1	+5V	1			1	+5V
		–DATA	2			2	–DATA
		+DATA	3			3	+DATA
		+DATA	3			3	+DATA

3	4	GND 4				4	GND	1					2				3					4

USB cable

Caution • Before making connections, read the instruction manual of the equipment to be connected.

•Use the optional USB cable to connect.

•Effective with USB only when the mouse is used.

•Do not use with any device other than a personal computer.

•When using with Windows 95, it is necessary to set so that USB can be used with version OSR 2.1 or higher. Depending on the kind or the version of the host controller, operation may not be possible in some cases.

•In the case of notebook type computers with a built-in pointing device such as a track ball, in some cases the built-in pointing device will have priority even if a mouse is connected and the mouse may not be selected.

In such case, disable the built-in pointing device and change the BIOS setting (system setup) so that an external mouse can be selected.

After changing the BIOS setting, perform the operations described in 1 - 3 above. Refer to the computer hardware manual concerning the BIOS setting.

Also, some computers may not have a utility program to operate a mouse. Refer to the computer hardware manual.

25

Image 25

Contents Contents FeaturesOutline For the Customers in U.K Power cord Video signal cablesBefore Use Video inputsDo not install on an unstable surface If a problem should occurDo not look through the lens when the lamp is on Use only the indicated power supplyDo not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Battery usage Care and maintenanceClean the projector interior once every two years Avoid installation in humid or dusty locationsAvoid excessively hot locations Sound volumeLens care Cabinet careNames and functions of each part Checking the package ContentsNames and functions of each part Names and functions of each part Remote control transmitter3Close the battery cover 1Remove the battery cover2Loading the batteries Typical LCD Projector and Screen Installation InstallationUsing the adjusters Top view Side viewTurn on the power to the connected equipment Turn on the main power switch of the projector I onBasic operations To projectTurn off the main power switch of the projector OFF Turning off the powerPlug & Play Press the STANDBY/ON button for approximately 1 secondFreeze function Cancelling the Freeze functionPress the Freeze button Changing the magnification ratio Magnify functionMoving the display area Returning to normal displayReturning to the initial settings Adjustments and functionsPress the Menu Using the Setup Menu SET UPInput Image OPT Connection to the RGB signal terminal Connection to the video signal terminalsInput signals Signal input jacksExample of computer signal Connection to the RGB signal terminalInitial set signals Connection to the RGB signal terminalConnecting the USB Mouse functions Connection to the control signal terminalControl signal jack Connection to the control signal terminalRS232C communication System Video Command data chartRequesting projector status Cleaning the Air filter Example of system setupPull out the power cord Remove the front air filterInstall the air filter Clean the air filter with a vacuum cleanerLamp Message tableIndicators TroubleshootingDimensional Diagram Limited Warranty About the warranty and after-serviceQR41981