BOXLIGHT XD-10m manual Usage Guidelines

Page 11

zoom ring

computer and video connectors

focus ring

keypad

power

switch powersecurity lock cord

connector

FIGURE 2

Side view of projector

Usage Guidelines

•Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•Transport the projector in a BOXLIGHT-approved hard or soft case.

3

Image 11

Contents Page EN 55022 Warning Safety CertificationsFCC Warning Canada Trademarks Declaration of ConformityPage Table of Contents Index AppendixSafety Terms Safety InstructionsSafety Definitions Safety Symbols Important Operating Considerations Customer ServiceUnpacking the Projector Image ResolutionIntroduction CompatibilityT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantyMake sure the projector and the computer are turned off Setting UP the ProjectorT t i n g O j e c t o r Connecting a Computer Connecting a Video Player Turning Off the Projector Powering up the Projector and Adjusting the ImageT t i n g O j e c t o r Adjusting the Projector Using the ProjectorBasic Image Adjustment I n g O j e c t o r Using the Remote Control Source keypad only or Data and Video remote only Using the Keypad and Remote ButtonsMenu/select Up/down arrow buttons Reset keypad onlyKeystone + remote only Forward/back buttons remote onlyUsing the On-Screen Menus Brightness Display MenuKeystone Blank screen ContrastTint ColorAuto Image Image Menu for Computer SourcesResize Vertical Position Manual SyncManual Tracking Horizontal PositionVideo Standard video sources only Image Menu for Video SourcesAuto Source Default SourceControl Menu Rear Projection ResetAdvanced Menu Language Menu Source Computer resolutionStatus Menu Lamp hours usedI n g O j e c t o r Replacing the Projection Lamp Maintenance & TroubleshootingCleaning the Lens Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Using the Security Lock Replacing the Batteries in the Remote ControlProblem Only the start-up screen displays Troubleshooting Problem The projector is not runningProblem Image is too wide or narrow for screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image isn’t centered on the screenCall Boxlight at 1-800-762-5757 or Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Problem Lamp shuts offAppendix SpecificationsStandard Accessories ship with the projector AccessoriesOptional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using SimulScan Using Video Mirroring with a PowerBook ComputerImage Width Projected Image SizeDistance to screen Diagonal Maximum MinimumIndex D e Page D e Limited Warranty Limitation of Liability