BOXLIGHT XD-10m manual Using the Keypad and Remote Buttons, Menu/select

Page 22

U s i n g	t h e	P r o j e c t o r

Using the Keypad and Remote Buttons

While the menus are displayed, the source and reset buttons on the keypad and the up and down arrow buttons on the remote act as menu navigation and adjustment buttons and the menu/select button acts as a select button. See “Using the On- Screen Menus” on page 16 for details.

LED

menu/select

menu/select

forward

source

back

data

keystonevideo

reset

NOTE: If you have turned Auto Source off (page 22), you may need to press the source button more than once to display an active source. The sources switch in this order: data analog, data digital, S-video, and composite video.

FIGURE 11

Keypad and remote buttons

Menu/select

Press the menu/select button to open the on-screen menus. Press menu/select again (while Exit is highlighted) to close the menus. (The menus automatically close after 30 seconds if no buttons are pressed.) When you close the menus, the projector saves any changes you made. For more information about the on-screen menus, see page 16.

Source (keypad only) or Data and Video (remote only)

When you have more than one source (computer and video) con- nected to the projector, select between them by pressing the source button on the keypad or the data or video button on the remote.

14

Image 22

Contents Page FCC Warning Canada Safety CertificationsEN 55022 Warning Declaration of Conformity TrademarksPage Table of Contents Appendix IndexSafety Definitions Safety Symbols Safety InstructionsSafety Terms Customer Service Important Operating ConsiderationsCompatibility Image ResolutionIntroduction Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP the Projector Make sure the projector and the computer are turned offT t i n g O j e c t o r Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the ProjectorT t i n g O j e c t o r Basic Image Adjustment Using the ProjectorAdjusting the Projector I n g O j e c t o r Using the Remote Control Menu/select Using the Keypad and Remote ButtonsSource keypad only or Data and Video remote only Forward/back buttons remote only Reset keypad onlyKeystone + remote only Up/down arrow buttonsUsing the On-Screen Menus Keystone Display MenuBrightness Color ContrastTint Blank screenResize Image Menu for Computer SourcesAuto Image Horizontal Position Manual SyncManual Tracking Vertical PositionImage Menu for Video Sources Video Standard video sources onlyControl Menu Default SourceAuto Source Advanced Menu ResetRear Projection Language Menu Lamp hours used Computer resolutionStatus Menu SourceI n g O j e c t o r Cleaning the Lens Maintenance & TroubleshootingReplacing the Projection Lamp Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Replacing the Batteries in the Remote Control Using the Security LockTroubleshooting Problem The projector is not running Problem Only the start-up screen displaysProblem Image isn’t centered on the screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image is too wide or narrow for screenProblem Lamp shuts off Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Call Boxlight at 1-800-762-5757 orSpecifications AppendixAccessories Standard Accessories ship with the projectorOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Using SimulScanDiagonal Maximum Minimum Projected Image SizeDistance to screen Image WidthIndex D e Page D e Limited Warranty Limitation of Liability