BOXLIGHT XD-10m manual I n g O j e c t o r

Page 20

U s i n g	t h e	P r o j e c t o r

The projector is equipped with a self-locking, quick-release eleva- tor foot and button.

To raise the projector:

1Press and hold the elevator button (Figure 9).

2Raise the projector to the height you want, then release the button to lock the elevator foot into position.

elevator button (under finger)

elevator foot

FIGURE 9

Adjusting the height of the projector

12

Image 20

Contents Page EN 55022 Warning Safety CertificationsFCC Warning Canada Declaration of Conformity TrademarksPage Table of Contents Appendix IndexSafety Terms Safety InstructionsSafety Definitions Safety Symbols Customer Service Important Operating ConsiderationsImage Resolution IntroductionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP the Projector Make sure the projector and the computer are turned offT t i n g O j e c t o r Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the ProjectorT t i n g O j e c t o r Adjusting the Projector Using the ProjectorBasic Image Adjustment I n g O j e c t o r Using the Remote Control Source keypad only or Data and Video remote only Using the Keypad and Remote ButtonsMenu/select Reset keypad only Keystone + remote onlyForward/back buttons remote only Up/down arrow buttonsUsing the On-Screen Menus Brightness Display MenuKeystone Contrast TintColor Blank screenAuto Image Image Menu for Computer SourcesResize Manual Sync Manual TrackingHorizontal Position Vertical PositionImage Menu for Video Sources Video Standard video sources onlyAuto Source Default SourceControl Menu Rear Projection ResetAdvanced Menu Language Menu Computer resolution Status MenuLamp hours used SourceI n g O j e c t o r Replacing the Projection Lamp Maintenance & TroubleshootingCleaning the Lens Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Replacing the Batteries in the Remote Control Using the Security LockTroubleshooting Problem The projector is not running Problem Only the start-up screen displaysProblem Color or text not being projected Problem The screen resolution is not rightProblem Image isn’t centered on the screen Problem Image is too wide or narrow for screenProblem Image is noisy or streaked Problem Lamp seems to be getting dimmerProblem Lamp shuts off Call Boxlight at 1-800-762-5757 orSpecifications AppendixAccessories Standard Accessories ship with the projectorOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Using SimulScanProjected Image Size Distance to screenDiagonal Maximum Minimum Image WidthIndex D e Page D e Limited Warranty Limitation of Liability