BOXLIGHT XD-10m manual I n t e n a n c e Troubleshooting

Page 38

M a i n t e n a n c e	&	T r o u b l e s h o o t i n g

7Install the new lamp module.

8Tighten the screw on the outside of the module.

9Press the yellow tab to reconnect the lamp module.

10Replace the lamp access grill by lining up the ribs on the grill with the marks on the bottom case and sliding the grill in the direction of the arrows on the bottom case.

11Plug in the power cord and press the Power switch to turn the projector back on.

12To reset the lamp hour counter in the Status menu, press and hold the reset button, then press the menu/select button (while still holding down the reset button) for 10 seconds.

Verify that the counter was reset by pressing the menu/select button and viewing the counter in the Status menu. See page 25 for details on the Status menu.

30

Image 38

Contents Page EN 55022 Warning Safety CertificationsFCC Warning Canada Declaration of Conformity TrademarksPage Table of Contents Appendix IndexSafety Terms Safety InstructionsSafety Definitions Safety Symbols Customer Service Important Operating ConsiderationsCompatibility Image ResolutionIntroduction Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP the Projector Make sure the projector and the computer are turned offT t i n g O j e c t o r Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the ProjectorT t i n g O j e c t o r Adjusting the Projector Using the ProjectorBasic Image Adjustment I n g O j e c t o r Using the Remote Control Source keypad only or Data and Video remote only Using the Keypad and Remote ButtonsMenu/select Forward/back buttons remote only Reset keypad onlyKeystone + remote only Up/down arrow buttonsUsing the On-Screen Menus Brightness Display MenuKeystone Color ContrastTint Blank screenAuto Image Image Menu for Computer SourcesResize Horizontal Position Manual SyncManual Tracking Vertical PositionImage Menu for Video Sources Video Standard video sources onlyAuto Source Default SourceControl Menu Rear Projection ResetAdvanced Menu Language Menu Lamp hours used Computer resolutionStatus Menu SourceI n g O j e c t o r Replacing the Projection Lamp Maintenance & TroubleshootingCleaning the Lens Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Replacing the Batteries in the Remote Control Using the Security LockTroubleshooting Problem The projector is not running Problem Only the start-up screen displaysProblem Image isn’t centered on the screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image is too wide or narrow for screenProblem Lamp shuts off Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Call Boxlight at 1-800-762-5757 orSpecifications AppendixAccessories Standard Accessories ship with the projectorOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Using SimulScanDiagonal Maximum Minimum Projected Image SizeDistance to screen Image WidthIndex D e Page D e Limited Warranty Limitation of Liability