Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of these steps.
•Using the remote control
Press 
/ 
on the projector or remote control to display the Keystone correction page. Press 
to correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
• Using the OSD menu
1. Press Menu/Exit and then press 
/ 
until the DISPLAY menu is highlighted.
2.Press 
to highlight Keystone and press Mode/Enter. The Keystone correction page
| displays. |
|
|
|
|
|
|
|
|
|
|
3. | Press | to correct keystoning at the top of | Press | / . |
| Press | / . | ||||
| |||||||||||
| the image or press | to correct keystoning |
| ||||||||
|
|
|
|
|
|
|
|
| |||
at the bottom of the image.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture.
•Using the remote control
1.Press Digital Zoom +/- to display the Zoom bar.
2. Press Digital Zoom + to magnify the center of the picture. Press the key repeatedly until the picture size is suitable for your need.
3. Use the directional arrows (
, 
, 
, 
) on the projector or remote control to navigate the picture.
4.To restore the picture to its original size, press
AUTO. You can also press Digital Zoom
•Using the OSD menu
1.Press Menu/Exit and then press 
/ 
until the DISPLAY menu is highlighted.
2.Press 
to highlight Digital Zoom and press Mode/Enter. The Zoom bar displays.
3.Repeat steps
4.Press 
on the projector repeatedly to magnify the picture to a desired size.
5.To navigate the picture, press Mode/Enter to switch to the paning mode and press the directional arrows (
, 
, 
, 
) to navigate the picture.