If you don’t use the floppy interface, disable it in Setup. This frees the floppy’s I/O addresses, IRQ6, and DMA channel 2 for use by other peripherals installed on the PC/104 bus.
Floppy Interface Connector (J14)
Table
Table
Pin # | Signal Name | Function | In/Out |
|
|
|
|
1 | KEY | Cable Key Pin | N/A |
2 | DEN | Speed/Precomp | OUT |
4 | IDX* | Index Pulse | IN |
6 | MO1* | Motor On 1 | OUT |
8 | DS2* | Drive Select 2 | OUT |
10 | DS1* | Drive Select 1 | OUT |
11 | MO2* | Motor On 2 | OUT |
12 | DIRC* | Direction Select | OUT |
14 | STEP* | Step | OUT |
15 | WD* | Write Data | OUT |
16 | WE* | Write Enable | OUT |
18 | TRKO* | Track 0 | IN |
20 | WP* | Write Protect | IN |
22 | RDD* | Read Data | IN |
24 | HS* | Head Select | OUT |
26 | DCHG* | Disk Change | IN |
- | Other Odd Pins | Signal grounds | N/A |
|
|
|
|
EIDE Hard Disk Interface
The Little Board P6d system provides an interface for up to four Integrated Device Electronics (IDE) peripheral devices, such as hard disk drives and
The primary IDE interface appears at connector J6, a
The secondary IDE interface appears at connector J7, also a
Table