Foundry Networks LS 648, LS 624 manual CLI Commands, no optical-monitor alarm interval

Maintaining the FastIron LS Hardware

•100FX-LR

CLI Commands

The show media command displays module information including link length, vendor name, vendor part number, vendor revision, and laser wavelength.

[no] optical-monitor <alarm interval>

Use this command to configure monitoring for all ports (system-wide), a range or ports, or a single port. The <alarm-interval> variable sets the interval in minutes between the sending of alarms and messages. The default interval is three minutes. When monitoring is enabled, console messages, syslog messages, and SNMP traps are sent when warranted by optical operating conditions, and a port is enabled.

show optic port/slot_number

This command displays optical monitoring information as a result of the optical-monitorconfiguration command. Information includes:

•temperature

•TX power

•RX power

•TX bias current Status values are:

•low-alarm

•low-warn

•normal

•high-warn

high-alarm

September 2007 © 2007 Foundry Networks, Inc. 5 - 9