Foundry Networks LS 648, LS 624 manual FLS648 Switch# show log

Maintaining the FastIron LS Hardware

To display the system log, enter the following command at any CLI level:

FLS648 Switch# show log

Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)

Buffer logging: level ACDMEINW, 8 messages logged

level code: A=alert C=critical D=debugging M=emergency E=error I=informational N=notification W=warning

Static Log Buffer:

Dynamic Log Buffer (50 entries):

at 0 days 0 hours 2 minutes 0 seconds, level alert

Temperature 48.0 C degrees, warning level 45.0 C degrees, shutdown level 55.0 C degrees

at 0 days 0 hours 1 minutes 0 seconds, level alert

Temperature 50.0 C degrees, warning level 45.0 C degrees, shutdown level 55.0 C degrees

Changing the Temperature Warning and Shutdown Levels on the FastIron LS

The default warning temperatures and the default shutdown temperatures for the FastIron LS are as follows: For the FLS624:

-Warning temperature is 62C (exhaust side)

-Shutdown temperature is 68C (exhaust side) For the FLS648:

-Warning temperature is 58C (exhaust side)

-Shutdown temperature is 62C (exhaust side)

NOTE: These temperatures reflect the temperature of the board inside the device.

To change the temperature at which the device sends a warning, enter a command such as the following at the Privileged EXEC level of the CLI:

FLS648 Switch# temperature warning 47

Syntax: temperature warning <value>

The <value> can be 0 – 125.

The default values for the FastIron LS are as follows:

For the FLS648:

-Warning temperature is 58C (exhaust side)

-Shutdown temperature is 62C (exhaust side) For the FLS624:

-Warning temperature is 62C (exhaust side)

-Shutdown temperature is 68C (exhaust side)

NOTE: These temperatures reflect the temperature of the board inside the device. You cannot set the warning temperature to a value higher than the shutdown temperature.

September 2007 © 2007 Foundry Networks, Inc. 5 - 3