Foundry Networks LS 624, LS 648 manual Connecting Switches to the RPS, FastIron LS648

Foundry FastIron LS Layer 2 Compact Switch Hardware Installation Guide

Figure 3.7 Attaching the adhesive feet

2.Set the device on a flat surface near an AC power source, making sure there are at least two inches of space on all sides for proper air flow.

Connecting Switches to the RPS

The following devices are supported by the FastIron RPS2-EIF: Foundry FastIron LS624 and

FastIron LS648.

CAUTION: DO NOT connect the RPS to an AC power source until DC power cords have been connected to the supported switches.

To connect switches to the RPS:

1.Connect one end of the AC cord to the AC receptacle on the supported switches, and the other end to a grounded power outlet.

Figure 3.8 Power receptacle

2.Connect one end of a DC cord to the redundant power receptacle on the supported switch and the other end to an available receptacle on the RPS.

3.Repeat steps 1 and 2 for connecting up to four supported switches to the RPS.

4.Connect one end of the AC cord to the AC receptacle on the RPS, and the other end to a grounded power outlet.

3 - 12 © 2007 Foundry Networks, Inc. September 2007