Onkyo HT-R8230 appendix Connecting antennas, Connecting an Outdoor FM Antenna

Page 15

Connecting antennas

Connecting an Outdoor FM Antenna

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.

FM 75

Notes

•Outdoor FM antennas work best outside, but usable results can sometimes be obtained when installed in an attic or loft.

•For best results, install the outdoor FM antenna well away for tall buildings, preferably with a clear line of sight to your local FM transmitter.

•Outdoor antenna should be located away from possible noise sources, such as neon signs, busy roads, etc.

•For safety reasons, outdoor antenna should be situated well away from power lines and other high-voltage equipment.

•Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

Using the 75/300-ohm Antenna Adapter

The 75/300-ohm antenna adapter can be used to connect an FM antenna using either 75-ohm coaxial cable or 300-ohm twin-core flat cable.

3.Move the small wire inside the adapter from position A to position B, as shown.

Position A

Wire

Position B

4.Insert the central conductor (1), as shown, and use a small pair of pliers to clamp the shielding and outer insulation sections of the cable (2), as shown.

✦

✦

✦

✦

 

 

 

✦✦

✦ ✦

✦

 

 

 

✦ ✦

 

 

 

Make sure the shielding is not touching the central conductor.

5.Refit the adapter’s cover, and then plug the adapter into the 75 Ω socket.

Using a TV/FM Antenna Splitter

It’s best not to use the same antenna for both FM and TV reception, as this can cause interference problems. If circumstances demand it, use a TV/FM antenna splitter, as shown.

Connecting 300-ohm Flat Cable

1. Using a screwdriver, loosen the two screws on the adapter, wrap the bare wires around the screws, and then retighten them, as shown.

2. Plug the adapter into the 75 Ω socket.

Connecting 75-ohm Coaxial Cable

1. Strip and prepare the 75 ohm

 

15 mm

 

coaxial cable, as shown.

 

 

 

6

3 6

 

 

 

 

mm

mm

 

mm

 

 

 

✦

✦

✦

✦

 

 

 

 

 

 

 

 

✦✦

✦ ✦

 

 

 

 

 

 

 

✦

 

 

 

 

 

 

 

 

 

 

 

 

 

 

✦ ✦

 

 

 

 

 

 

 

 

 

1/8"

1/4"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5/8"

 

2. Using your fingernails or a small screwdriver, lever the adapter’s tabs outward and remove the cover, as shown.

TV/FM antenna splitter

To AV reciever

To TV (or VCR)

Connecting an Outdoor AM Antenna

If good reception cannot be achieved using the supplied AM loop antenna, an outdoor AM antenna can be used in addition to the loop antenna, as shown.

Outdoor antenna (aerial)

Insulated antenna cable

AM loop antenna

AM

Outdoor AM antennas work best when installed outside horizontally, but good results can sometimes be obtained indoors by mounting horizontally above a window. Note that the AM loop antenna should be left connected.

Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents HT-R8230 Avis Important Safety InstructionsFor Canadian models PrecautionsPower For U.S. modelsFM/AM Tuner Features FeaturesSupplied accessories Amplifier FeaturesUsing the Remote Controller Before Using the HT-R8230Index to parts and controls Index to parts and controls AC Outlet Rear panelAntenna 14 Front Speakers A, Center Speaker and Surround Speakers@ Adjust / button Remote controllerPreset / button = Mode buttonsVideo Connecting to audio/video equipmentVCR Video Connecting to audio/video equipmentStandard speaker placement of the speaker system a Positioning speakers/Connecting speakersConnecting to the speaker system B Positioning speakers/Connecting speakersHow to connect to the speaker terminals Connecting to the speaker system aAdjusting the position of the AM indoor antenna Connecting antennasConnecting the supplied FM and AM indoor antennas Adjusting the position of the FM indoor antennaStrip and prepare the 75 ohm Connecting antennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaDirect change function Connections for remote controlPower on/ready function Power off functionStart playing the selected source Enjoying music or videos with the HT-R8230Press STANDBY/ON Selecting a sourceSpeaker setup Setting the crossover frequencyPress Speaker Adjust twice Speaker setup Adjusting each speaker’s relative volume balance Test tone Setting the subwoofer mode Press Subwoofer Mode on the unit→ Subwoofer Mode 1 Default Subwoofer ModeChanging the default settings according to your connections There are two ways to select radio stations Tuning into a radio station Press TunerTuning in a weak frequency only for FM stations Listening to the radioListening to the radio Presetting radio stationsSelecting preset stations Press Tuner to switch the input source to the tunerTurning on/off the speaker system A/B Muting the sound remote controller only Press MutingListening through headphones Various functions common to all the sourcesUsing the sleep timer remote controller only Press Sleep Various functions common to all the sourcesChanging the display Press Display To fix the Auto to DTS or PCM Setting the input signal formatEnjoying multi channel sources Using analog multi channel inputEnjoying the listening modes Enjoying the listening modes Selecting the listening modePress one of the listening mode buttons Input source and available listening modeUsing the audio adjust functions Audio adjust functionAudio adjust function Recording a source Using the remote controller with your other AV components DVD modeUse the buttons as explained below Using the remote controller with your other AV components CD modeTape mode RCVR/TAPE Amplifier Remote controller Symptoms Causes Remedies Pages TroubleshootingOther TroubleshootingSymptoms Causes Remedies TunerTuner Section SpecificationsAmplifier Section Video SectionMemo Memo 3 4 3 8 6

HT-R8230 specifications

The Onkyo HT-R8230 is a versatile home theater receiver that brings high-quality audio and video performance to the home entertainment experience. Designed for both music lovers and movie enthusiasts, this model offers a range of features and technologies designed to transform any living space into a dedicated home theater.

At the heart of the HT-R8230 is its robust amplification system, which delivers powerful output through its multiple channels. With a 7.1 channel configuration, this receiver boasts an impressive 110 watts per channel at 8 ohms, allowing it to drive a variety of speaker setups effectively. This ensures that viewers can enjoy clear sound whether they're watching action-packed films or listening to their favorite music playlists.

One of the standout features of the Onkyo HT-R8230 is its advanced surround sound processing capabilities. It supports popular formats like Dolby Digital and DTS, providing an immersive audio experience that complements high-definition video sources. The built-in Audyssey MultEQ technology enhances sound calibration, customizing the audio output to suit the specific acoustics of the room, allowing for uniform sound distribution and clarity.

Connectivity is another strong suit for the HT-R8230. With multiple HDMI inputs, component video, and composite inputs, this receiver allows for seamless integration with various devices, from Blu-ray players and gaming consoles to streaming devices. The HDMI connections support 4K video pass-through, ensuring that users can enjoy cutting-edge video quality with compatible sources.

The Onkyo HT-R8230 also features an onboard radio tuner and supports various audio formats, including MP3 and WMA. Users can enjoy their favorite FM/AM radio stations or stream music from digital sources. Furthermore, this receiver incorporates zone 2 capabilities, allowing listeners to enjoy audio in different areas of the house, adding versatility to home entertainment.

Another notable characteristic is the remote control system, which provides easy navigation through settings and features, making it convenient for users to access their preferred audio and visual configurations. The user-friendly interface, combined with the ability to customize and save sound profiles, enhances the overall user experience.

Overall, the Onkyo HT-R8230 delivers a well-rounded combination of power, connectivity, and smart audio processing, making it a fantastic addition to any home theater system. Its ability to handle various multimedia sources while providing enriching sound quality positions it as a reliable choice for consumers seeking an affordable yet effective home entertainment solution.
Top Page Image Contents