Onkyo HT-R8230 appendix Changing the default settings according to your connections

Changing the default settings according to your connections

If equipment couldn’t be connected in accordance with the default settings, or your preferred settings differ from the default settings, you can change the settings as described below.

DIGITAL INPUT

DVD TAPE

Switch the source from TAPE to MD

You can set the AV receiver to show “MD” when the TAPE source is selected by pressing TAPE on the unit.

For example, follow the steps below to assign Optical to the DVD device connected to the DIGITAL INPUT OPTICAL jack.

1Press TAPE to select the input source.

2Press and hold TAPE on the unit until the display changes (for about 2 seconds).

To restore the display

Press and hold TAPE on the unit until the display changes (for about 2 seconds).

Setting the digital inputs

The digital input terminal for each input source is pre-set, as described in the table below. It is necessary to change the settings if the components you connected differ from input source’s default settings.

Default setting

Input source	Digital input
CD	OPTICAL
TUNER
TAPE	– – – –
VIDEO 3	– – – –
VIDEO 2	– – – –
VIDEO 1	– – – –
DVD	COAXIAL

–– – – : Available for digital input but not set in initial setting. : Not available for digital input.

1.Press DVD.

The DVD input is selected and “DVD” appears in the display.

2.Press DIGITAL INPUT.

The current DVD setting (Coaxial) appears.

3.Press DIGITAL INPUT repeatedly to select “Optical”.

Pressing DIGITAL INPUT repeatedly will change the setting as follows:

Select if connected to DIGITAL

INPUT COAXIAL.

Select if connected to DIGITAL

INPUT OPTICAL.

Select if the input source is not from a digital input jack.

About three seconds after “DVD ← Optical” is selected, the original display appears and the setting is completed.

If you have selected digital input, you can also select the input signal format (refer to “Setting the input signal format” on page 26).

21