3M 9000PD manual Hanging the 3M Digital WallDisplay, Unpacking the 3M Digital WallDisplay

Page 17

3M™ Digital WallDisplay

Installation and System Setup

 

 

 

Hanging the 3M Digital WallDisplay

Unpacking the 3M Digital WallDisplay

1. Place the shipping container face up on the floor and open the end previous opened.

2. Slide the shipping tray out of the shipping container.

3.Remove the accessory box(es) from the top support.

4.Remove the top support.

5.Remove the plastic bag from the 3M Digital WallDisplay by lifting the top of the unit and

pushing the bag towards the bottom of the unit. Then set down the top.

6. Lift up the bottom and remove the bag completely.

7.Remove and set aside the tape holding the projection arm in place.

8. Remove the projection arm shipping foam, by opening the projection arm from the left.

9. Replace the tape to hold the projection arm in place while hanging on the wall.

© 3M 2005. All Rights Reserved.

17

Image 17
Contents Operator’s Guide This page intentionally left blank for printed version Contents Troubleshooting MaintenanceService Information Menu SystemIntroduction Safety InformationThank You for Choosing 3M Intended UseTo reduce the risk associated with hazardous voltage Introduction 3M Digital WallDisplayTo reduce the risk associated with muscle strain and impact To reduce the risk associated with chokingTo reduce the risk associated with tripping over cables To reduce the risk associated with radio interferenceImportant Notes Trademarks Product Safety Label3M Digital WallDisplay Technical Support PatentsFCC Statement-Class a EEC Statement-Class aModel Differences Model Identification and DifferencesIdentify Model What’s Next? ContentsOptional Accessories Part Identification 3M Digital WallDisplay Features Recommendation and Things to Consider Before Installing Installation and System SetupLocation of Unit Air VentilationInstallation and System Setup 3M Digital WallDisplay Installing the Wall BracketInstallation for a Hollow Wall-Drywall Unpacking Wall Bracket and HardwareUnpacking the 3M Digital WallDisplay Hanging the 3M Digital WallDisplay3M 2005. All Rights Reserved System Setup Operation 3M Digital WallDisplay OperationStartup Shutdown Remote Control Unit 3M Digital WallDisplay Remote Control UnitFeatures Forward Keypad Rear Keypad Installing or Replacing Batteries Menu Navigation Menu SystemColorful-Bright Slider Menu System 3M Digital WallDisplayWarm-Cool Slider Volume SliderMute Menu Function Input Select Menu Reset All MenuMain Returns to main menu Exit Leaves the menu system Image Adj Sub-MenuBanding Tools Sub-Menu General Maintenance MaintenanceLamp Usage Onscreen Lamp MessagesLamp Replacement 5a 5b 3M Digital WallDisplay Resetting Lamp Hours Replacing ProjectionScreen Optical Engine Adjustment 3M Digital WallDisplay Replace the optical adjustment door Common Problems and Solutions TroubleshootingMessage Meaning Onscreen MessagesOrdering Parts or Getting Information Service InformationReplacement Parts Appendix 3M Digital WallDisplay SpecificationsAppendix Computer Compatibility Input/Output Signal Specifications3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe