3M 9000PD manual Replacing ProjectionScreen

Page 37

3M™ Digital WallDisplay	Maintenance

Replacing ProjectionScreen

Replacing the 3M Digital WallDisplay screen is very simple.

1.Turn off the 3M Digital WallDisplay and disconnect the power cord from the wall outlet.

2.Remove the right and left side bezels. There are two ways to remove it. Either snap it off or insert a screwdriver into the notch located on the sides of each bezel, near the top. The bezel will easily snap on and off for screen replacement.

3.Slide the screen straight out of the open side. Be sure to allow approximately 4 feet of clear space on either side of the 3M Digital WallDisplay to do this.

4.Insert new screen into the open side and slide into place. Ensure that the screen is centered before replacing the side bezels. The bezels have ribs on the inside that could damage the screen if it is not centered.

5.Insert the bottom of the bezel first, then snap bezel back into place.

© 3M 2005. All Rights Reserved.

37

Image 37

Contents Operator’s Guide This page intentionally left blank for printed version Contents Troubleshooting MaintenanceService Information Menu SystemIntroduction Safety InformationThank You for Choosing 3M Intended UseTo reduce the risk associated with hazardous voltage Introduction 3M Digital WallDisplayTo reduce the risk associated with muscle strain and impact To reduce the risk associated with chokingTo reduce the risk associated with tripping over cables To reduce the risk associated with radio interferenceImportant Notes Trademarks Product Safety Label3M Digital WallDisplay Technical Support PatentsFCC Statement-Class a EEC Statement-Class aIdentify Model Model Identification and DifferencesModel Differences Optional Accessories ContentsWhat’s Next? Part Identification 3M Digital WallDisplay Features Recommendation and Things to Consider Before Installing Installation and System SetupLocation of Unit Air VentilationInstallation and System Setup 3M Digital WallDisplay Installing the Wall BracketInstallation for a Hollow Wall-Drywall Unpacking Wall Bracket and HardwareUnpacking the 3M Digital WallDisplay Hanging the 3M Digital WallDisplay3M 2005. All Rights Reserved System Setup Startup OperationOperation 3M Digital WallDisplay Shutdown Features Remote Control UnitRemote Control Unit 3M Digital WallDisplay Forward Keypad Rear Keypad Installing or Replacing Batteries Menu Navigation Menu SystemColorful-Bright Slider Menu System 3M Digital WallDisplayWarm-Cool Slider Volume SliderMute Menu Function Input Select Menu Reset All MenuBanding Image Adj Sub-MenuMain Returns to main menu Exit Leaves the menu system Tools Sub-Menu General Maintenance MaintenanceLamp Usage Onscreen Lamp MessagesLamp Replacement 5a 5b 3M Digital WallDisplay Resetting Lamp Hours Replacing ProjectionScreen Optical Engine Adjustment 3M Digital WallDisplay Replace the optical adjustment door Common Problems and Solutions TroubleshootingMessage Meaning Onscreen MessagesReplacement Parts Service InformationOrdering Parts or Getting Information Appendix 3M Digital WallDisplay SpecificationsAppendix Computer Compatibility Input/Output Signal Specifications3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe