3M 9000PD manual Lamp Replacement

Page 33

3M™ Digital WallDisplay	Maintenance

Lamp Replacement

1.Turn the power off and disconnect the power cord from the outlet.

2.Allow approximately 45 minutes for the lamp to cool, if necessary.

3.There are two indentations behind the top of the facade, near each end. Grasp facade plate at each indentation and pull out and down to remove plate.

Facade

4.Loosen the self-contained screw at the upper righthand corner of the lamp housing door with a standard screwdriver.

5.Two black wires connect to the lamp cartridge by a black plastic receptacle on the right side of the lamp cartridge.

Lamp Receptacle Black

CartridgeWires

© 3M 2005. All Rights Reserved.

33

Image 33

Contents Operator’s Guide This page intentionally left blank for printed version Contents Troubleshooting MaintenanceService Information Menu SystemIntroduction Safety InformationThank You for Choosing 3M Intended UseTo reduce the risk associated with hazardous voltage Introduction 3M Digital WallDisplayTo reduce the risk associated with muscle strain and impact To reduce the risk associated with chokingTo reduce the risk associated with tripping over cables To reduce the risk associated with radio interferenceImportant Notes Trademarks Product Safety Label3M Digital WallDisplay Technical Support PatentsFCC Statement-Class a EEC Statement-Class aModel Identification and Differences Identify ModelModel Differences Contents Optional AccessoriesWhat’s Next? Part Identification 3M Digital WallDisplay Features Recommendation and Things to Consider Before Installing Installation and System SetupLocation of Unit Air VentilationInstallation and System Setup 3M Digital WallDisplay Installing the Wall BracketInstallation for a Hollow Wall-Drywall Unpacking Wall Bracket and HardwareUnpacking the 3M Digital WallDisplay Hanging the 3M Digital WallDisplay3M 2005. All Rights Reserved System Setup Operation StartupOperation 3M Digital WallDisplay Shutdown Remote Control Unit FeaturesRemote Control Unit 3M Digital WallDisplay Forward Keypad Rear Keypad Installing or Replacing Batteries Menu Navigation Menu SystemColorful-Bright Slider Menu System 3M Digital WallDisplayWarm-Cool Slider Volume SliderMute Menu Function Input Select Menu Reset All MenuImage Adj Sub-Menu BandingMain Returns to main menu Exit Leaves the menu system Tools Sub-Menu General Maintenance MaintenanceLamp Usage Onscreen Lamp MessagesLamp Replacement 5a 5b 3M Digital WallDisplay Resetting Lamp Hours Replacing ProjectionScreen Optical Engine Adjustment 3M Digital WallDisplay Replace the optical adjustment door Common Problems and Solutions TroubleshootingMessage Meaning Onscreen MessagesService Information Replacement PartsOrdering Parts or Getting Information 3M Digital WallDisplay Specifications AppendixAppendix Computer Compatibility Input/Output Signal Specifications3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe