3M 9000PD manual Startup, Operation 3M Digital WallDisplay

Page 20

Operation	3M™ Digital WallDisplay

Operation

Startup

1.Plug power cord into wall socket.

2.Flip on the Master Power Switch beneath the lower left corner of the 3M Digital WallDisplay, near the 3M label. This should stay on at all times. Now the 3M Digital WallDisplay is in standby mode. The large oval On/Off Button will be backlit amber after several seconds.

3.Press the On/Off Button in the center of the lower front panel. The projection arm will extend outward from its housing at the top of the 3M Digital WallDisplay unit. Do not block its movement.

4.When the projection arm is fully extended, the lamp will turn on automatically. It will reach full illumination in approximately 60 seconds. The On/Off Button should then be backlit green.

20	© 3M 2005. All Rights Reserved.

Image 20

Contents Operator’s Guide This page intentionally left blank for printed version Contents Maintenance TroubleshootingService Information Menu SystemSafety Information IntroductionThank You for Choosing 3M Intended UseIntroduction 3M Digital WallDisplay To reduce the risk associated with hazardous voltageTo reduce the risk associated with muscle strain and impact To reduce the risk associated with chokingTo reduce the risk associated with radio interference To reduce the risk associated with tripping over cablesImportant Notes Product Safety Label TrademarksPatents 3M Digital WallDisplay Technical SupportFCC Statement-Class a EEC Statement-Class aModel Differences Model Identification and DifferencesIdentify Model What’s Next? ContentsOptional Accessories Part Identification 3M Digital WallDisplay Features Installation and System Setup Recommendation and Things to Consider Before InstallingLocation of Unit Air VentilationInstalling the Wall Bracket Installation and System Setup 3M Digital WallDisplayInstallation for a Hollow Wall-Drywall Unpacking Wall Bracket and HardwareHanging the 3M Digital WallDisplay Unpacking the 3M Digital WallDisplay3M 2005. All Rights Reserved System Setup Operation 3M Digital WallDisplay OperationStartup Shutdown Remote Control Unit 3M Digital WallDisplay Remote Control UnitFeatures Forward Keypad Rear Keypad Installing or Replacing Batteries Menu System Menu NavigationColorful-Bright Slider Menu System 3M Digital WallDisplayVolume Slider Warm-Cool SliderMute Menu Function Reset All Menu Input Select MenuMain Returns to main menu Exit Leaves the menu system Image Adj Sub-MenuBanding Tools Sub-Menu Maintenance General MaintenanceLamp Usage Onscreen Lamp MessagesLamp Replacement 5a 5b 3M Digital WallDisplay Resetting Lamp Hours Replacing ProjectionScreen Optical Engine Adjustment 3M Digital WallDisplay Replace the optical adjustment door Troubleshooting Common Problems and SolutionsOnscreen Messages Message MeaningOrdering Parts or Getting Information Service InformationReplacement Parts Appendix 3M Digital WallDisplay SpecificationsAppendix Input/Output Signal Specifications Computer Compatibility3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe