3M 9000PD manual Onscreen Messages, Message Meaning

Page 42

Troubleshooting3M™ Digital WallDisplay

Common Problems and Solutions

Symptom	Cause	Solution

Desired input source cannot be	The input source is not active.	Connect an active input source to
detected.	A signal must be present for the	unit.
	input to be selected.
	The input device (e.g. computer,	Turn on input source
	VHS player, etc.) is not turned on.

The remote control does not work	The remote control is not facing	Face the remote control toward
	the remote control sensor.	the remote control sensor.
	The remote control is too far from	Operate the remote control within
	the sensor.	5 meters.
	An obstruction is between the	Remove obstacle.
	remote control and the sensor.
	The remote control’s batteries are	Replace batteries.
	exhausted.

The menu system will not display.	The menu system will not display	Connect an active input source to
	without an input source displayed.	unit.

Onscreen Messages

Message	Meaning

No input is detected	3M Digital WallDisplay is not receiving a signal from
	an external source. Check the cable connections and
	verify power is on and external source is working.

Please change the lamp	The lamp has 1400–1499 hours on it and needs to
	be changed.

There are (x) hours of lamp life remaining.	The lamp has 1500–1579 hours on it and needs to
The WallDisplay will shut off in 40 minutes	be changed.

There are (x) hours of lamp life remaining.	When the lamp has 1580 hours or more on it, the
The WallDisplay will shut off in 5 minutes	message will flash, and the power will turn off after
	5 minutes.

42	© 3M 2005. All Rights Reserved.

Image 42

Contents Operator’s Guide This page intentionally left blank for printed version Contents Service Information MaintenanceTroubleshooting Menu SystemThank You for Choosing 3M Safety InformationIntroduction Intended UseTo reduce the risk associated with muscle strain and impact Introduction 3M Digital WallDisplayTo reduce the risk associated with hazardous voltage To reduce the risk associated with chokingTo reduce the risk associated with radio interference To reduce the risk associated with tripping over cablesImportant Notes Product Safety Label TrademarksFCC Statement-Class a Patents3M Digital WallDisplay Technical Support EEC Statement-Class aModel Identification and Differences Identify ModelModel Differences Contents Optional AccessoriesWhat’s Next? Part Identification 3M Digital WallDisplay Features Location of Unit Installation and System SetupRecommendation and Things to Consider Before Installing Air VentilationInstallation for a Hollow Wall-Drywall Installing the Wall BracketInstallation and System Setup 3M Digital WallDisplay Unpacking Wall Bracket and HardwareHanging the 3M Digital WallDisplay Unpacking the 3M Digital WallDisplay3M 2005. All Rights Reserved System Setup Operation StartupOperation 3M Digital WallDisplay Shutdown Remote Control Unit FeaturesRemote Control Unit 3M Digital WallDisplay Forward Keypad Rear Keypad Installing or Replacing Batteries Colorful-Bright Slider Menu SystemMenu Navigation Menu System 3M Digital WallDisplayVolume Slider Warm-Cool SliderMute Menu Function Reset All Menu Input Select MenuImage Adj Sub-Menu BandingMain Returns to main menu Exit Leaves the menu system Tools Sub-Menu Lamp Usage MaintenanceGeneral Maintenance Onscreen Lamp MessagesLamp Replacement 5a 5b 3M Digital WallDisplay Resetting Lamp Hours Replacing ProjectionScreen Optical Engine Adjustment 3M Digital WallDisplay Replace the optical adjustment door Troubleshooting Common Problems and SolutionsOnscreen Messages Message MeaningService Information Replacement PartsOrdering Parts or Getting Information 3M Digital WallDisplay Specifications AppendixAppendix Input/Output Signal Specifications Computer Compatibility3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe