Rackmount Solutions XRT Series manual INSTALLATION, Step by Step, Battery Pack Connection Diagram

Page 14

INSTALLATION, STEP BY STEP

1.Insure UPS Power switch is OFF. Place the optional XRTBP battery pack(s), if used, and XRT UPS in its final location.

2.When installing the XRT1000 and above UPS’s or the XRT600 with optional battery pack(s):

a)Remove the self stick protective strip from the rear of the XRT600 (not required on XRT1000 , 1500, and 2000), and from the optional battery pack cable.

b)Loosen the retainer screws on the rear of the UPS and drop the retainer bracket down.

c)Plug the battery pack cable connector into the XRT remote battery pack connector insuring connections mate RED to RED and BLACK to BLACK. Push the retaining bracket “up” to secure the battery connector in place and re-tighten the screws.

d) Verify the bracket will not allow removal of the connector. Each battery pack is “daisy chained” in a similar fashion with the cable from the last battery pack connected to the previous pack. Remove the protective strips only from the battery connectors that are used.

NOTE: When the protective strip is removed from the XRT UPS or the XRTBP cable connector, battery system voltage (48 VDC) is present at these connector contacts. Please keep the connector contacts covered with the protective strip when not mated with another connector.

Battery Pack Connection Diagram

13

Image 14
Contents Page Page XRT Series User’s Manual Introduction Para Systems Life Support PolicyPage Radio Frequency Interference Receiving InspectionPlease Save the Packing Materials Important Safety Instructions This Manual Contains Important Safety InstructionsInstructions Importantes Concernant LA Sécurité System Description Features Built in Self Test Protection Strategies InstallationInstallation Placement Page INSTALLATION, Step by Step Battery Pack Connection DiagramXRT600, XRT1000, XRT1500 and XRT2000 Back panels XRT600 Front Panel Showing Load LED’s Front Panel Load Menu on LCD Screen LED Front Panel Top four LED’s Green provide 3 functions OperationFront Panels Second bottom row of LED’s provide status informationStartup SwitchesTest/Alarm Silence Button Menu Flow Status Menu Test Menu Setup Menu Config Menu Alarms and Warnings Options System Batteries Storage InstructionsBattery Replacement Troubleshooting Symptom Possible Cause Action to TakeInitial Error Messages Model XRT1000 and above error messages LCD Display Possible Cause Action to TakeOperating Faults Self Test Obtaining Service Mark the RMA # on the outside of all packages. The factoryPage General Product Specifications Cetl CSA Remote Communications Remote Direct Communications LBWBattery Pack and Runtime Specifications XRT600Load TWO R E E XRTBP1 XRTBP3 Limited Product Warranty