INITIAL ERROR MESSAGES
As soon as the UPS is first turned on, it performs a series of self tests. If the self tests fail then the UPS will report the failure and display the fault. If the self test passes, but the UPS was shut down previously due to a fault, the previous fault code or message will be displayed. This feature allows you to determine why the UPS shut down. The LCD screen will display the words “Error Detected” on the top line of the screen, and one of the messages in the Error Code list is shown on the second line.
Model XRT600 LED Display Error Codes
Displayed in binary code
LED |
|
|
DISPLAY | POSSIBLE CAUSE | ACTION TO TAKE |
ooox | Low ac input | Verify incoming ac |
ooxo | Input ac to high | Verify incoming ac |
ooxx | Input AC frequency out of | Verify incoming freq. for this |
| range for unit. | model. |
oxoo | Excessive output current | Verify output load |
| being drawn | matches unit. |
oxox | Fan not running | Verify nothing has |
|
| gotten into the fan |
oxxo | Fan or air | Clear air passages |
| passages blocked |
|
oxxx | Battery pack is bad or | Check battery voltage |
| disconnected | and connections |
xooo | UPS has had a | Call for service |
| hardware fault |
|
xoox | Output voltage | Call for service |
| is too high |
|
xoxo | Output voltage | Call for service |
| is too low |
|
On the XRT600, these messages can be cleared by pressing the Test/Alarm Silence button.
29