Rackmount Solutions PRO700iE English, On-Line/On-Battery/Boost/Buck LED Fault LED Overload LED

Page 6

On-Line/On-Battery/Boost/Buck LED

English

On-Line/On-Battery/Boost/Buck LED

Fault LED

Overload LED

Weak/Bad Battery LED

On/Off/Test Button

Press and release the ON/OFF/Test Button after 1 beep to turn the UPS ON or OFF (see section 4).

On-Line

On-Battery

Buck Boost

The On-Line/On-Battery/Boost and Buck (green) LED illuminates in a steady state when the UPS is on and supplying AC power to the load. The LED blinks and the audible alarm sounds, when supplying battery power to the load. The LED blinks and no audible alarm when the UPS is in either the boost or the buck mode.

The Fault (red) LED illuminates when the UPS has detected an inter- nal fault. (see section 5)

The Overload (yellow) LED illuminates when the loads connected to the UPS exceeds the UPS power rating. (see section 5)

The Weak/Bad Battery (red) LED illuminates when the UPS has detected that the batteries are Weak/Bad. Battery replacement might be required. (see section 5)

5

Image 6

Contents Page PRO-E Series Users Manual This symbol indicates Risk of Electrical Shock IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSThis symbol indicates ATTENTION This symbol indicates Direct Current SupplyAUTHORIZED SERVICE PERSONNEL ONLY Receiving Inspection Para Systems Life Support PolicyOn-Line/On-Battery/Boost/Buck LED Fault LED Overload LED WARNING The 230V models are NETWORK PROTECTION ONLY REAR PANEL120V Models 230V ModelsINSTALLATION PLACEMENT INSTALLATIONCONNECTING YOUR EQUIPMENT CHARGING THE BATTERY CONNECTING THE UPS TO AN AC SOURCECHECKING THE SITE WIRING FAULT COMMUNICATIONS PORT CONNECTION OPTIONALON / OFF / Test Button DIP SWITCH SETTINGSTURNING THE UNIT ON/OFF SELF TESTWEAK/BAD BATTERY ALARMS ON BATTERYLOW BATTERY WARNING UPS FAULTCOMMUNICATIONS PORTS RS232 and USB Press and release the On/Off Check the specifications seeEnglish even though there isREPLACING THE BATTERY BATTERY REPLACEMENT PROCEDURE Yuasa9. Disconnect the positive red wire from the battery positve terminal IF THE UPS REQUIRES SERVICE PRO700E MODEL NUMBERPRO500E PRO1100EFunction DefaultThese items may require optional software or hardware FactoryPara Systems Inc. Para Systems warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of purchase. For equip- ment sites within the United States and Canada, this warranty covers repair or replacement of defective equipment at the discretion of Para Systems. Repair will be from the nearest authorized service center. Replacement parts and warranty labor will be borne by Para Systems. For equipment located outside of the United States and Canada, Para Systems only covers faulty parts. Para Systems products repaired or replaced pursuant to this warranty shall be war- ranted for the unexpired portion of the warranty applying to the original product. This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase LIMITED PRODUCT WARRANTY ContinuedRobert Calhoun DECLARATION OF CONFORMITYEnglish