CAUTION! Connect the UPS to a two pole, three wire grounding 
AC wall outlet. The receptacle must be connected to the appropriate 
branch protection (circuit breaker or fuse). Connection to any other 
type of receptacle may result in a shock hazard and violate local elec- trical codes.
CAUTION! To reduce the risk of electrical shock in conditions where |
the load equipment grounding cannot be verified, disconnect the UPS |
from the AC wall outlet before installing a computer interface cable. |
Reconnect the power cord only after all signaling connections are made. |
English
WARNING: Risk of Electrical Shock. Hazardous live parts inside these power supplies are energized from the battery even when the AC input is disconnected.
To
1.If the UPS is on press and release the On/Off/Test button.
2.Disconnect the UPS from the AC wall outlet.
3.To
This Uninterruptible Power Supply (UPS) contains potentially hazardous volt- ages. DO NOT attempt to disassemble the UPS. This UPS contains no user serviceable parts. Repairs and battery replacement must be performed by
AUTHORIZED SERVICE PERSONNEL ONLY.
NOTICE: This equipment has been tested and found to comply with
the limits for a Class B computing device in accordance with the speci- 
fications in Subpart J of Part 15 of FCC Rules and the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference of
the Canadian Department of Communications. These limits are designed to provide reasonable protection against such interference in a residential installa- tion. This equipment generates and uses radio frequency and if not installed and used properly, that is, in strict accordance with the manufacturer's instruc- tions, this equipment may cause interference to radio and television reception. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
!
!Relocate the computer with respect to the receiver.
!Move the computer away from the receiver.
!Plug the computer into a different outlet so that the computer and receiver are on different branch circuits.
!Shielded communications interface cables must be used with this product.
WARNING: Changes or modifications to this unit not expressly ap- proved by the party responsible for compliance could void the user's authority to operate the equipment.
3