Rackmount Solutions PRO1500E, PRO700iE, PRO500iE Rear Panel, English, 120V Models, 230V Models

Page 7

REAR PANEL

English

REAR PANEL	1	10

2

120V Models
	4	3							9
		3


5										8

6 7

1.The Information/Rating Label.

2.The Battery Backup and Surge output power receptacles are NEMA 5-15R type (IEC 320 C13 sockets for 230V models).

3.The USB Communications Interface Port is for UPS monitoring and control.

4.The RS232 Communications Interface Port is for UPS monitoring and control.

5.The Dipswitches are for setting the Inverter output voltage.

6.The input power cord has a NEMA 5-15P Plug (IEC 320 C14 socket for 230V models).

7.The input circuit breaker will trip in the event the load exceeds the UPS’s power rating.

8.The RJ11/RJ45 modular connectors are used for 10 Base-T Network/Fax/ Modem protection.

WARNING: The 230V models are NETWORK PROTECTION ONLY.

9.The Surge ONLY output power receptacles are NEMA 5-15R type (IEC 320 C13 sockets for 230V models).

NOTE: The Surge ONLY output power receptacles are only on the following

models: PRO500E, PRO700E, PRO500iE, PRO700iE.

10.The Site Wiring Fault (SWF) LED illuminates when the UPS detects an improperly wired AC wall outlet (120V models only).

		1
		1
230V Models		2
		2

		3													9


5		4														8
		4




		6									7

6

Image 7

Contents Page PRO-E Series Users Manual This symbol indicates Direct Current Supply IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSThis symbol indicates ATTENTION This symbol indicates Risk of Electrical ShockAUTHORIZED SERVICE PERSONNEL ONLY Para Systems Life Support Policy Receiving InspectionOn-Line/On-Battery/Boost/Buck LED Fault LED Overload LED 230V Models REAR PANEL120V Models WARNING The 230V models are NETWORK PROTECTION ONLYINSTALLATION INSTALLATION PLACEMENTCONNECTING YOUR EQUIPMENT COMMUNICATIONS PORT CONNECTION OPTIONAL CONNECTING THE UPS TO AN AC SOURCECHECKING THE SITE WIRING FAULT CHARGING THE BATTERYSELF TEST DIP SWITCH SETTINGSTURNING THE UNIT ON/OFF ON / OFF / Test ButtonUPS FAULT ALARMS ON BATTERYLOW BATTERY WARNING WEAK/BAD BATTERYCOMMUNICATIONS PORTS RS232 and USB even though there is Check the specifications seeEnglish Press and release the On/OffREPLACING THE BATTERY Yuasa BATTERY REPLACEMENT PROCEDURE9. Disconnect the positive red wire from the battery positve terminal IF THE UPS REQUIRES SERVICE PRO1100E MODEL NUMBERPRO500E PRO700EFactory DefaultThese items may require optional software or hardware FunctionPara Systems Inc. Para Systems warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of purchase. For equip- ment sites within the United States and Canada, this warranty covers repair or replacement of defective equipment at the discretion of Para Systems. Repair will be from the nearest authorized service center. Replacement parts and warranty labor will be borne by Para Systems. For equipment located outside of the United States and Canada, Para Systems only covers faulty parts. Para Systems products repaired or replaced pursuant to this warranty shall be war- ranted for the unexpired portion of the warranty applying to the original product. This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase Continued LIMITED PRODUCT WARRANTYDECLARATION OF CONFORMITY Robert CalhounEnglish