Rackmount Solutions PRO700iE, PRO1500E, PRO500iE manual COMMUNICATIONS PORTS RS232 and USB, English

Page 12

COMMUNICATIONS PORTS (RS232 and USB)

COMMUNICATIONS PORTS (RS232 and USB)

The RS232 communication port is a standard DB9 female with both RS232 and simulated contact closure capability. The PRO-E series UPS will poll the port and activate the port for RS232 or contact closure in accordance with the type of cable it finds connected to the port. To change the port configuration requires the unit be turned off and restarted with the desired cable connected. The pinout for the port is depicted per the chart below.

Pin 1: EPO Emergency Power Off (pull and hold this pin low to turn off the UPS, release this pin from low to turn to restart the UPS)

Pin 2: /TXD

Pin 3: /RXD and receive ups shutdown command

Pin 4: Simulated contact closure AC fail, NO

Pin 5: Ground

Pin 6: Simulated contact closure low battery warning, NO

Pin 7: Simulated contact closure AC fail, NC

Pin 8: AC fail signal (high to low signal)

Pin 9: Not Used

NOTE: See the SentryII CD for the Power Monitoring Software installation. See the USB Driver CD for the USB installation.

English

11

Image 12

Contents Page PRO-E Series Users Manual IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS This symbol indicates ATTENTIONThis symbol indicates Risk of Electrical Shock This symbol indicates Direct Current SupplyAUTHORIZED SERVICE PERSONNEL ONLY Receiving Inspection Para Systems Life Support PolicyOn-Line/On-Battery/Boost/Buck LED Fault LED Overload LED REAR PANEL 120V ModelsWARNING The 230V models are NETWORK PROTECTION ONLY 230V ModelsINSTALLATION PLACEMENT INSTALLATIONCONNECTING YOUR EQUIPMENT CONNECTING THE UPS TO AN AC SOURCE CHECKING THE SITE WIRING FAULTCHARGING THE BATTERY COMMUNICATIONS PORT CONNECTION OPTIONALDIP SWITCH SETTINGS TURNING THE UNIT ON/OFFON / OFF / Test Button SELF TESTALARMS ON BATTERY LOW BATTERY WARNINGWEAK/BAD BATTERY UPS FAULTCOMMUNICATIONS PORTS RS232 and USB Check the specifications see EnglishPress and release the On/Off even though there isREPLACING THE BATTERY BATTERY REPLACEMENT PROCEDURE Yuasa9. Disconnect the positive red wire from the battery positve terminal IF THE UPS REQUIRES SERVICE MODEL NUMBER PRO500EPRO700E PRO1100EDefault These items may require optional software or hardwareFunction FactoryPara Systems Inc. Para Systems warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of purchase. For equip- ment sites within the United States and Canada, this warranty covers repair or replacement of defective equipment at the discretion of Para Systems. Repair will be from the nearest authorized service center. Replacement parts and warranty labor will be borne by Para Systems. For equipment located outside of the United States and Canada, Para Systems only covers faulty parts. Para Systems products repaired or replaced pursuant to this warranty shall be war- ranted for the unexpired portion of the warranty applying to the original product. This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase LIMITED PRODUCT WARRANTY ContinuedRobert Calhoun DECLARATION OF CONFORMITYEnglish