Rackmount Solutions PRO500iE, PRO700iE Installation Placement, English, Connecting Your Equipment

Page 8

INSTALLATION PLACEMENT

English

INSTALLATION PLACEMENT

The PRO-E series is intended to be install in a temperature controlled environ- ment that is free of conductive contaminants. Select a location which will pro- vide good air circulation for the UPS at all times. Avoid locations near heating devices, water or excessive humidity, or where the UPS is exposed to direct sunlight. Route power cords so they cannot be walked on or damaged.

Operating Temperature (Maximum): 0 to 40 degrees C (+32 to 104 degrees F)

Operating Elevation: 0 to 3,000m (0 to 10,000 ft)

Operating and Storage Relative Humidity: 95%, non-condensing

Storage Temperature: -15 to +45 degrees C (+5 to +113 degrees F)

Storage Elevation: 0 to 15,000m (0 to +50,000 ft)

INSTALLATION

Be sure to read the installation placement and all the cautions before installing the UPS. Place the UPS in the final desired location and complete the rest of the installation procedure. USE CAUTION: The UPS is heavy. Use the appropriate number of personnel when installing the UPS.

CONNECTING YOUR EQUIPMENT

Plug the equipment into the output receptacles on the rear panel of the UPS. Do not use extension cords, adapter plugs, power strips or surge strips on the output of the UPS. Ensure that you do not exceed the maximum output rating of the UPS (refer to the UPS's back panel or the Electrical Specifications in this manual).

CAUTION! DO NOT connect a laser printer to the output receptacles on the UPS, unless the UPS is rated 2000VA or greater. A laser printer draws significantly more power when printing than at idle and

may overload the UPS.

7

Image 8

Contents Page PRO-E Series Users Manual IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS This symbol indicates ATTENTIONThis symbol indicates Risk of Electrical Shock This symbol indicates Direct Current SupplyAUTHORIZED SERVICE PERSONNEL ONLY Receiving Inspection Para Systems Life Support PolicyOn-Line/On-Battery/Boost/Buck LED Fault LED Overload LED REAR PANEL 120V ModelsWARNING The 230V models are NETWORK PROTECTION ONLY 230V ModelsCONNECTING YOUR EQUIPMENT INSTALLATION PLACEMENTINSTALLATION CONNECTING THE UPS TO AN AC SOURCE CHECKING THE SITE WIRING FAULTCHARGING THE BATTERY COMMUNICATIONS PORT CONNECTION OPTIONALDIP SWITCH SETTINGS TURNING THE UNIT ON/OFFON / OFF / Test Button SELF TESTALARMS ON BATTERY LOW BATTERY WARNINGWEAK/BAD BATTERY UPS FAULTCOMMUNICATIONS PORTS RS232 and USB Check the specifications see EnglishPress and release the On/Off even though there isREPLACING THE BATTERY BATTERY REPLACEMENT PROCEDURE Yuasa9. Disconnect the positive red wire from the battery positve terminal IF THE UPS REQUIRES SERVICE MODEL NUMBER PRO500EPRO700E PRO1100EDefault These items may require optional software or hardwareFunction FactoryPara Systems Inc. Para Systems warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of purchase. For equip- ment sites within the United States and Canada, this warranty covers repair or replacement of defective equipment at the discretion of Para Systems. Repair will be from the nearest authorized service center. Replacement parts and warranty labor will be borne by Para Systems. For equipment located outside of the United States and Canada, Para Systems only covers faulty parts. Para Systems products repaired or replaced pursuant to this warranty shall be war- ranted for the unexpired portion of the warranty applying to the original product. This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase LIMITED PRODUCT WARRANTY ContinuedRobert Calhoun DECLARATION OF CONFORMITYEnglish