RS-232C
External control device setup
13.Red ADC gain Adjustment (Color R) (Command2:w)
➜Adjust the Red gain of ADC part.(RGB)
Transmission
[ j ] [w] [ ] [Set ID] [ ] [Data] [Cr]
Data Min : 0 ~ Max : 64
* Refer to ‘Real data mapping 1’.
Ack
[w] [ | ] [Set ID] [ ] [OK] [Data] [x] |
Data | Min : 0 ~ Max : 64 |
16. Low Power (Command2:q)
➜To reduce the power consumption of the projector.
Transmission
[ j ] [q] [ ] [Set ID] [ ] [Data] [Cr]
Data 0 : Low Power Off
1 : Low Power On
Ack
[q] [ ] [Set ID] [ ] [OK] [Data] [x]
Data 0 : Low Power Off
1 : Low Power On
14.Green ADC gain Adjustment (Color G) (Command2:y)
➜Adjust the Green gain of ADC part.(RGB)
Transmission
[ j ] [y] [ ] [Set ID] [ ] [Data] [Cr]
Data Min : 0 ~ Max : 64
* Refer to ‘Real data mapping 1’.
Ack
[y] [ | ] [Set ID] [ ] [OK] [Data] [x] |
Data | Min : 0 ~ Max : 64 |
15.Blue ADC gain Adjustment (Color B) (Command2:z)
➜Adjust the Blue gain of ADC part.(RGB)
Transmission
[ j ] [z] [ ] [Set ID] [ ] [Data] [Cr]
Data Min : 0 ~ Max : 64
* Refer to ‘Real data mapping 1’.
Ack
[z] [ | ] [Set ID] [ ] [OK] [Data] [x] |
Data | Min : 0 ~ Max : 64 |
17. Auto Configure (Command2:u)
➜To adjust picture position and minimize image shaking automatically. It works only in RGB mode.
Transmission
[ j ] [u] [ ] [Set ID] [ ] [Data] [Cr]
Data 1 : To set
Ack
[u][ ] [Set ID] [ ] [OK] [Data] [x] Data 1 : To set
18. Input Select (Command2:b)
➜To select input source for the Set.
Transmission
[x] [b] [ ] [Set ID] [ ] [Data] [Cr]
Data | 20 | : Video | 30 | : | 40 | : Component | |
| 50 | : | 60 | : | 70 | : | |
| 80 | : |
|
|
|
|
|
Ack |
|
|
|
|
|
|
|
|
|
|
|
| |||
[b] [ | ] [Set ID] [ ] [OK] [Data] [x] |
|
|
| |||
Data | 20 | : Video | 30 | : | 40 | : Component | |
| 60 | : | 80 | : |
|
|
|
*The transmission data for
30