Viewing video images
A. Connecting the projector to video equipment
Preparation:
• Make sure that the power of the projector and that of the video equipment are turned off.
ENGLISH
Connecting to a video player, etc.
Video player, or the like
To audio
output 
3
terminals 
To video
4
output terminal
1 To VIDEO IN terminals
Audio/video cable
To audio input
2 terminals
1.Connect one end (yellow) of the supplied audio/video cable to the VIDEO IN terminal of the projector.
2.Connect one end (white and red) of the supplied audio/ video cable to the audio input terminals (L/MONO, R) of the projector.
3.Connect the other end (yellow) of the audio/video cable to the video output terminal of the video equipment.
4.Connect the other end (white and red) of the audio/video cable to the audio output terminals (L, R) of the video equipment.
Video player, or the like
When the video equipment is equipped with the
| To |
|
| output | 2 To audio |
To | terminal | |
1 IN terminal |
| output |
|
| terminals |
4
Audio/video cable
To audio input
3 terminals
AUDIO OUT | To audio |
| input |
| terminals |
Audio cable (option)
1.Connect one end of a commercially available
2.Connect the other end of the
3.Connect one end (white and red) of the supplied audio/ video cable to the audio input terminals (L/MONO, R) of the projector.
4.Connect the other end (white and red) of the supplied audio/video cable to the audio output terminals (L, R) of the video equipment.
For audio connection:
1.Connect one end of an audio cable to the AUDIO OUT terminal of the projector.
2.Connect the other end (white and red) of the audio cable to
the audio input terminals (L, R) of the audio equipment.
•When the audio cable is connected to the AUDIO OUT ter- minal, the speaker output is muted.
•When connecting a monophonic video device, use the white (L) terminal to connect the audio cable. (The same audio signal is output from the channels L and R of the AUDIO OUT terminal.)
•Also read the instruction manual of the equipment to be connected.
•Contact your dealer for details of connection.
When a TV tuner or VCR is connected:
When you use this projector with a TV tuner or VCR connected, no image may appear or a message of NO SIGNAL may appear on the screen when you change the channel via any channel that is not being received. In such a case, set the channels of the TV tuner or VCR again. To avoid such symptom, use the TV tuner or VCR with its channel skip function (that is a function not to display channels that are not being received) enabled.