Microtek CX4 manual Connecting To A Notebook, DVI Source, Data Projector

Page 14

DVI Source

DVI Source

DVI

DVI Cable

Data Projector

Connecting To A Notebook

Before connecting this projector to a notebook, make sure that both machines have the power shut off.

1.Connect either end of the Computer Cable to the Computer In port of the projector, then connect the other end of the Computer Cable to the Monitor Out port of the notebook.

If the functions of the wireless mouse on the Remote Control need to be operated, please make the connections to each signal cable according to the steps numbered 2~ 3 below:

2.Connect the Control Cable to the Control port of the projector.

3.Connect the PS/2 Mouse connector of the Control Cable to the PS/2 mouse port of the notebook.

You may connect your computer to the USB interface of the projector so to enable the function of the wireless mouse on the remote control. Please follow the step numbered 4 for connection.

13

Image 14

Contents Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Remote Control Information Transporting Your ProjectorRemote Control Briefing Functions Warning：INSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Computer Connecting To A Desktop Computer5. Remove the computer mouse cable 8. Tighten all connector screws to ensure secure connections4. Connect the Control Cable to the Control port of the projector Data Projector Connecting To A NotebookDVI Source Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connecting To An Audio Source Connection of an audio cable from a computer sourceConnection of an audio cable from a video audio source Data Projector Connecting To An External SpeakerSpeaker or PA HOW TO OPERATE THIS PROJECTORTurning The Equipment On And Off Page How To Adjust The Projected Image The Focus and Zoom FunctionsThe Auto Key The Resize keyHow To Operate This Projector Functions The Buttons on the Operation Panel of the Projector & Their FunctionsButtons likeThe Buttons on the Remote Control & Their Functions Note The ZOOM & FOCUS functions are not suitable to this modelThe life of the lamp has ended, please replace with Examine The Projector StatusThe life of the lamp will soon end, please prepare a USING THE OSD MENU OSD Menu How To Access The OSD MenuHow To Change OSD Settings BrightnessPosition Black LevelContrast ImageMiscellaneous Auto ConfigurationInformation Save Input SelectVideo Projection Mode VolumeKeystone MouseLanguage MAINTENANCE Cleaning the Air Filter Cleaning the LensCleaning the Projector Case The Steps of Cleaning the Air FilterReplacing The Projector Lamp The Steps of Replacing a Lamp4. Lift up the handle and pull out the lamp 1. Turn the power of the projector off and unplug the power cord3. Loosen the screws on the lamp case with a coin or screw driver 7. Tighten the lamp case you took off in step 8. Position the lamp cover you took off in stepTROUBLESHOOTING When the Projector Lamp does not light up Problem With The ProjectorWhen the Power Led Indicator does not light up The Power Indicator remains redNo image appears on the screen Problems With The Image Or SoundThe Power Indicator is blinking red The words ‘No Signal’ appear on the screen Abnormal Image ColoringUnstable Image Displayed by VHS Video Player No response with remote controlNo Sound SPECIFICATIONS TECHNICALProjector lamp GeneralOptical Environmental Mechanical with lens and feetElectrical Supported Monitor Displays Resize DisplaySupport Modes Computer In and Monitor Connector Pin Assignments