Microtek CX4 manual Replacing The Projector Lamp, The Steps of Replacing a Lamp

Page 42

Replacing The Projector Lamp

6.The cleaning process is finished at this moment. Please follow the proper operations indicated in this manual when using this projector.

Replacing The Projector Lamp

A new lamp should be replaced according to the following conditions:

Replace the lamp when the image displayed by this projector seems too dark or too dim.

When the Red and Orange Indicator LED of this projector blinks alternately, this indicates that the lamp life is going to end soon.

When the Red Indicator LED of this projector is lit, it means the lamp life of this projector has been exhausted.

Please contact the dealer of this projector for purchasing a new lamp.

The Steps of Replacing a Lamp

Warning: Have the lamp cool down before replacing it, or the hot lamp will burn you severely.

41

Image 42

Contents Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Remote Control Information Transporting Your ProjectorRemote Control Briefing Functions Warning：INSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Computer Connecting To A Desktop Computer8. Tighten all connector screws to ensure secure connections 4. Connect the Control Cable to the Control port of the projector5. Remove the computer mouse cable Connecting To A Notebook DVI SourceData Projector Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connecting To An Audio Source Connection of an audio cable from a computer sourceConnection of an audio cable from a video audio source Connecting To An External Speaker Speaker or PAData Projector HOW TO OPERATE THIS PROJECTORTurning The Equipment On And Off Page How To Adjust The Projected Image The Focus and Zoom FunctionsThe Auto Key The Resize keyHow To Operate This Projector Functions The Buttons on the Operation Panel of the Projector & Their FunctionsButtons likeThe Buttons on the Remote Control & Their Functions Note The ZOOM & FOCUS functions are not suitable to this modelExamine The Projector Status The life of the lamp will soon end, please prepare aThe life of the lamp has ended, please replace with USING THE OSD MENU OSD Menu How To Access The OSD MenuHow To Change OSD Settings BrightnessPosition Black LevelContrast ImageAuto Configuration InformationMiscellaneous Input Select VideoSave Projection Mode VolumeKeystone MouseLanguage MAINTENANCE Cleaning the Air Filter Cleaning the LensCleaning the Projector Case The Steps of Cleaning the Air FilterReplacing The Projector Lamp The Steps of Replacing a Lamp1. Turn the power of the projector off and unplug the power cord 3. Loosen the screws on the lamp case with a coin or screw driver4. Lift up the handle and pull out the lamp 7. Tighten the lamp case you took off in step 8. Position the lamp cover you took off in stepTROUBLESHOOTING When the Projector Lamp does not light up Problem With The ProjectorWhen the Power Led Indicator does not light up The Power Indicator remains redProblems With The Image Or Sound The Power Indicator is blinking redNo image appears on the screen The words ‘No Signal’ appear on the screen Abnormal Image ColoringNo response with remote control No SoundUnstable Image Displayed by VHS Video Player SPECIFICATIONS TECHNICALGeneral OpticalProjector lamp Mechanical with lens and feet ElectricalEnvironmental Supported Monitor Displays Resize DisplaySupport Modes Computer In and Monitor Connector Pin Assignments